ADP 7610
Programme selector knob
ON / OFF button
Start button
Switches "on" when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Indicators
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Add rinse aid
Wash cycle
Pre-Rinse
Washing
Programmes
Pre-Rinse
Quickwash
*) 5)
Eco
1) *) 5)
Normal
*) 5)
Normal
5)
Intensive
1)
Reference programme for energy label in compliance with EN 50242
regulations;
2)
Refer to "User instructions";
3)
Program data obtained in conformity with European standard EN 50242.
Values may vary in relation to usage, e.g.: different loads, water
temperatures - above or below 15°C - as well as water hardness and
power supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: "nk_customer@whirlpool.com".
Whirlpool is a registered trademark of Whirlpool USA
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Drying
Programme
end
Programme chart
Loading instructions
cold
Crockery to be washed later.
Lightly soiled crockery with no dried-on
40°C
food.
50°C
Normally soiled crockery.
50°C
Normally soiled crockery.
65°C
Normally or heavily soiled crockery.
Recommended programme for heavily soiled
70°C
crockery, especially suitable for pans and
saucepans.
Options
"Delayed start" button
The wash cycle can be programmed to start after
3-6-9 hours. Then press the Start button. The wash
programme will start at the set time.
"Half Load" button
The half load cycle can be used for the upper and
lower rack. Select the required programme then
press the "Half Load" button. The light comes on
and goes off at the end of the programme.
The "Half Load" function can be used with
programmes marked with an *.
Antibacterial rinse
This function adds an antibacterial rinse at the end
of the wash cycle, thereby guaranteeing a perfectly
clean and sanitized load. The lamp will light up when
the function is activated. If the temperature is not
maintained during the antibacterial cycle (e.g. if the
door is opened and remains open for a long time),
the lamp will start blinking to indicate that
sanitation is not guaranteed.
Detergent
A
-
X
X
X
X
X
4)
The bacteria removal efficiency has been tested by the Institut Pasteur
de Lille (France), based on the NF EN 13697 standard of November
2001.
5)
These programmes can be used with the Antibacterial rinse option.
(We reserve the right to make technical modifications)
GB
4)
2)
3)
Consumption
B
Litres kWh
Minutes
-
5.0
0.02
10
-
13.0
0.70
30
-
13.0
1.35
90
X
16.0
1.05
160
X
16.0
1.65
100
X
17.0
1.90
135
5019 396 98063
WH/I/B/GB