Crate TG10R - Guitar Amplifier Manual

OVERVIEW

1. INPUT: Connect your guitar to this jack by means of a shielded instrument cable.
2. OD LEVEL: Use this control to adjust the volume and intensity of the Overdrive channel. This control is only active when the OD/Clean switch (#3) is depressed.
3. OD/CLEAN: Use this switch to select the OD channel (switch depressed) or the Clean channel (switch in the out position). The OD channel gives you sounds ranging from crunchy rhythm to screaming leads, while the Clean channel gives you sounds from sparkling clean to slightly crunchy.
4. CLEAN LEVEL: Use this control to adjust the volume of the Clean channel. This control is only active when the OD/Clean switch (#3) is in the out position.
5. HIGH: Use this control to adjust the output level of the high frequencies. Rotating this control counter clockwise reduces the high frequency output; rotating it clockwise increases it.
6. LOW: Use this control to adjust the output level of the low frequencies. Rotating this control counter clockwise reduces the low frequency output; rotating it clockwise increases it.
7. REV LEVEL:Use this control to adjust the amount of reverberation added to the signal. With the control in the fully counter clockwise position the signal is "dry" (no reverb). As you rotate the control clockwise the amount of reverb increases.
8. CD INPUT: Use these RCA jacks to connect an external source (such as a CD player, tape player or rhythm machine) to the amplifier. The signal at these jacks is summed into a mono signal which is sent to the internal power amp circuit. Use the external source's output level control to adjust the signal for the proper mix with your instrument.
9. HEADPHONES: Use this jack to connect a pair of stereo headphones for private listening. The external speaker is disconnected when headphones are in use.
10. POWER LED: This LED illuminates when power is applied to the amplifier.
11. POWER SWITCH: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch depressed).
12. AC LINE IN: (Rear panel, not shown) The grounded power cord should only be plugged into a grounded power outlet that meets all applicable electrical codes and is compatible with the voltage, power, and frequency requirements stated on the rear panel. Do not attempt to defeat the safety ground connection.

TG10R TECHNICAL SPECIFICATIONS

The TG10R is covered with a durable Tolex material: wipe it clean with a lint-free cloth.
Never spray cleaning agents onto the cabinet. Avoid abrasive cleansers which would damage the finish.
Crate continually develops new products, as well as improves existing ones. For this reason, the specifications and information in this manual are subject to change without notice.

Block Diagram

www.crateamps.com
@2004 SLM Electronics, a division of St. Louis Music, Inc • 1400 Ferguson Avenue • St. Louis, MO 63133 18-950-02 • 05/17/04