Debug.conf - Siemens SIMATIC S7-1500 Manual

}
D.3

debug.conf

To enable debug mode, transfer the configuration file "debug.conf" to the TM NPU using the
SIMATIC Memory Card.
Requirement
In order to access the debug web page of the module, the following requirements must be
met:
• The debug server must be enabled in the engineering.
• The configuration file "debug.conf" is present on the SIMATIC Memory Card.
• The MAC address specified in the configuration file "debug.conf" is the same as the actual
MAC address of the module.
• The keyword "DebugOn" is set.
NOTE
If one of these four requirements is not met, the web page cannot be reached.
Structure of the configuration file
The configuration file "debug.conf" contains the following information:
• DebugOn
Supported character sets: UTF-8, CP1252
Permitted line endings: CR-LF (Windows), LF (Unix), CR (Mac)
Procedure
1. Create or edit the configuration file "debug.conf".
The file is in JSON format and contains exactly one entry.
2. Copy the configuration file "debug.conf" to the "config" folder on the
SIMATIC Memory Card.
Technology Module TM NPU
Equipment Manual, 07/2023, A5E46384784-AC
},
"required": [ "server","localPath" ]
Configuration files
D.3 debug.conf
59