Table of Contents
Advertisement
Installation:
Cat6 Network Cable - follow the IEEE-568B wiring standard:
1.
Orange/White
2.
Orange
3.
Green/White
4.
Blue
5.
Blue/White
6.
Green
7.
Brown/White
Connection:
1.
Connect HDMI input with HDMI output of source device
2.
Connect IR blaster extension cable to the IR extender out port
3.
Connect RJ45 port with RJ45 input port of HDMI extender RX
4.
Connect HDMI output of HDMI extender RX to HDMI input of HDTV and set the
source input to the correct HDMI input channel
Troubleshooting:
Display shows "Waiting for Connection":
Ensure power supply is firmly connected
Display indicates there is a signal loss:
Check all connections
Connect the signal source directly to the display device to ensure there is a
signal output. Change the signal source if necessary.
Degraded video signal:
Check cable lengths between the TX to the switch, the switch to RX
Ensure the connection between each level is within required ranges
Press the RESET button on the TX/RX front panel, reset and reconnect
Advertisement
Table of Contents
Need help?
Do you have a question about the OMX-HDMI-HDB1X8 and is the answer not in the manual?
Questions and answers