Table of Contents
Advertisement
Available languages
Available languages
WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
WARNING: To reduce the risk of injury, read the
instruction manual.
Intended Use
This LED light with magnifying lens is intended for
household use.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
Definitions: Safety Alert Symbols and Words
This instruction manual uses the following safety alert
symbols and words to alert you to hazardous situations and
your risk of personal injury or property damage.
DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death or
serious injury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or
serious injury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderate injury.
(Used without word) Indicates a safety related message.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result in
property damage.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
precautions should always be followed, including
the following:
a ) Read all the instructions before using
the tool.
b ) To reduce the risk of injury, close supervision is
necessary when a tool is used
near children.
c ) To reduce the risk of electrical shock, do not put
tool in water or other liquid. Do not place or store
tool where it can fall or be pulled into a tub or sink.
d ) Only use attachments recommended or sold by
the manufacturer.
e ) Turn the tool off when not in use.
f ) Do not operate any tool after it malfunctions or is
dropped or damaged in any manner. Return tool to
the nearest authorized service facility for examination,
repair, or electrical or mechanical adjustment.
g ) For indoor household use only.
h ) Do not expose tool to wet or damp areas.
When using the tool, basic
i ) Do not expose tool to rain or snow,
store indoors.
SAVE THESE INSTRUCTIONS
Specific Safety Rules
WARNING: Do not place the tool in a position
which may cause anyone to intentionally or
unintentionally stare into the LED lights. Serious
eye injury could result.
WARNING: Fire hazard. Do not operate tool or
charger near flammable liquids or in gaseous or
explosive atmospheres. Internal sparks may ignite
fumes causing personal injury.
•
Do not put the light or mirror under the magnifier lens
Additional Safety Information
WARNING: Never modify the power tool or any part of
it. Damage or personal injury could result.
WARNING: Fire risk- do not leave in area that
may get direct sunlight. Do not use around
combustible materials.
CAUTION: When not in use, fold down unit as
shown in Figure E so will not cause a tripping or
falling hazard. Some tools may easily be knocked
over.
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
OPM .................... oscillations per
minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
Wh ...................... watt hours
Ah ....................... amp hours
BATTERIES AND CHARGERS
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the
safety instructions below and then follow charging
procedures outlined. When ordering replacement battery
packs, be sure to include the catalog number and voltage.
English
or AC ........... alternating current
or AC/DC .... alternating or direct
current
...................... Class II Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
PSI....................... pounds per square
inch
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
do not stare into
the light
..................... wear respiratory
protection
..................... wear eye protection
..................... wear hearing
protection
..................... read all
documentation
3
Advertisement
Table of Contents
