Hybrid Xt Anemometer; Operation; Calibration; Hybrid Xt Vane - NRG Systems HYBRID XT VANE WRA User Manual

NRG User Manual
Hybrid XT Vane & Anemometer | WRA

Hybrid XT Anemometer

Kit #18015 | FG #4718
Square wave Output | 5m Cable

Operation

The Hybrid XT anemometer provides a high-level square wave output where the frequency (Hz)
is proportional to the wind speed. The square wave amplitude is determined by the power
supply voltage.
A typical logger/controller input stage may consist of overvoltage protection, low pass filter
(corner frequency of 100 Hz), limiter, and comparator. If unsure of your input circuit design,
please consult with NRG.

Calibration

If the Hybrid XT sensor has been calibrated, an individual calibration report has been shipped
with the sensor. If the calibration report should get lost, you may contact NRG with the sensor
serial number for a copy.

Hybrid XT Vane

Kit # 18016 | FG # 5762
4-20mA | 5m Cable
Operation
The Hybrid XT 4-20 mA Vane provides an industry-standard 4-20 mA output signal sourced by
the sensor. The output range of 4-20 mA corresponds to 0-359 degrees.

South Mark

The Hybrid XT vane uses the mounting bolt hole and "Toward Rotor label as the South mark
(180°).
Hybrid_ XT_Vane_&_Anemometer_WRA_Manual
Rev. 4.0
support@nrgsystems.com | Page 7