Water Connections; Cold Water Connection; Hot Water Connection; Hard Water Connection - Miele PW 6241 MF Installations Plan

Water connections

Cold water connection

Required flow pressure
Maximum flow rate (if no hot water and hard water supply)
Maximum flow rate
Threaded union required (male thread, to be provided by customer in accordance with
DIN 44991, flat sealing)
Length of water inlet hose supplied
*With liquid dispensing

Hot water connection

Maximum permissible hot water temperature
Required flow pressure
Maximum flow rate
Threaded union required (male thread, to be provided by customer in accordance with
DIN 44991, flat sealing)
Length of water inlet hose supplied

Hard water connection

Required flow pressure
Maximum flow rate
Threaded union required (male thread, to be provided by customer in accordance with
DIN 44991, flat sealing)
Length of water inlet hose supplied

Condensate connection (indirect steam heating only)

Threaded union for condensate connection (on site)
Condensate trap, dirt filter and steam shut-off valve must be installed by the customer on site.

Waste water (drain valve)

Maximum waste water temperature
Machine-side drain connection (external diameter)
On-site drain (internal diameter)
Maximum flow rate
A vented combined pipe is required to drain the waste water. If several machines are connected to a single drain pipe, this should be
sufficiently large to allow all machines to drain simultaneously.

Securing the machine

Fittings

4 x wood screws DIN 571 (Ø x length)
4 x plugs (Ø x length)
Fixing the machine in place is absolutely essential.
Fastenings for floating screed must be supplied by the customer on site.
en - Technical data
100–1000 kPa (1–10 bar)
74 (79,5*) l/min
26 (31,5*) l/min
2 (3*) x 1550 mm
100–1000 kPa (1–10 bar)
1 x 1550 mm
100–1000 kPa (1–10 bar)
2 x 1550 mm
½" female thread
75 x 1,9 x 110 mm (Muffe DN 70)
12 mm x 90 mm
16 mm x 80 mm
3/4"
60 °C
16 l/min
3/4"
32 l/min
3/4"
95 °C
HT DN 70
200 l/min
37