Panasonic KX-NS700 Feature Manual page 217

–
If the destination trunk supports End of Call Detection, a paging call can be made after dialling "#".
–
If the transferred call is forwarded to another outside destination, COS settings are ignored.
•
If the cellular phone's number is registered in system speed dialling, its COS will be the COS of
the extension specified as the CLI destination.
•
If the cellular phone's number is not registered in system speed dialling, its COS will be the COS
of the trunk that the transferrer is using.
•
Operation is as follows, depending on the "10.7.1 PBX Configuration—[2-7-1] System—Class of
Service—COS Settings—CO & SMDR—
Call Detection on the destination trunk:
–
Case 1: Transfer to CO is enabled
Transfer is available.
–
Case 2: Transfer to CO is disabled and the destination trunk supports End of Call Detection
A reorder tone is heard. (Consultation hold can be released by pressing "#".)
–
Case 3: Transfer to CO is disabled and the destination trunk does not support End of Call
Detection
Transfer is cancelled, and the conversation returns to the trunk on hold.
–
If the call is transferred to an ICD group, the call will wait in a queue until answered, but the Queuing
Time Table will not function.
–
When using this feature, do not use the Executive Busy Override feature to interrupt the established
call.
Redial with DTMF " " when receiving a trunk call (before the transfer destination—cellular
phone—answers).
•
It is possible to redial by using the DTMF tone " " before the transfer destination trunk (cellular phone)
answers.
•
If the transfer destination (cellular phone) is a line that does not support answer notification, outgoing
dial completion is considered as answering.
•
If the destination trunk supports End of Call Detection, screened transfer is available. If the transferring
party dials "#" while talking to the called party, the call can be put back on consultation hold.
•
If the destination trunk does not support End of Call Detection, the call is transferred unscreened.
•
DISA Call Transfer to Outside User
When a call is received through DISA and the receiving extension is set to forward the call to an extension
(including over a TIE connection) or an outside destination, the call can be forwarded automatically to an
outside telephone number if the following conditions are met:
•
An outside telephone number (e.g., a cellular phone number) is registered as the forward destination
of the receiving extension.
•
The forward destination's telephone number is registered in the System Speed Dial of the receiving
extension.
•
The forward destination's telephone number is set in the CLI Destination of the receiving extension.
•
Automatic Walking COS is enabled for the receiving extension.
After a conversation is established with the forward destination (e.g., a cellular phone number), it is possible
to establish a Conference call, perform Call Splitting, and page with a call on hold to transfer the call. This
is the same as DISA Call Transfer from Outside Destination. For details, see "DISA Call Transfer from
Outside Destination".
[Example]
a.
Outside Caller calls Extn. 101 through DISA.
b.
Extn. 101 forwards the call to Cellular Phone-1.
Outside Caller establishes a conversation with Cellular Phone-1.
c.
Cellular Phone-1 presses "#" to put the conversation on hold, and then transfers the call to Cellular
Phone-2.
At this point, the CLIP information shown on Cellular Phone-2 may be one of the following:
2.16.1 Direct Inward System Access (DISA)
Transfer to CO" setting and the availability of End of
Feature Manual 217