Installation Guide - Black & Decker BDT50 Series Instruction Manual

SET UP & USE

INSTALLATION GUIDE

When you open the box, you should have received:
Portable dehumidifier
User Guide
Castors (4)
Continuous Drain Kit
To Install Castors:
1. Remove castors from the water collection bucket.
For the 70 pint model (BDT70), the four castors can be taken out from the side
of the bucket directly (see fig 1).
For the 30 pint (BDT30) and 50 pint (BDT50) models, check if the castors are
under the lid of the bucket. If so, remove lid to access castors, then replace lid
before operation. (see fig. 2)
2. Tilt the dehumidifier no more than
45 degrees and push to insert the castors
into the base of the unit. Make sure the ring
around the castor is flush against the bottom
of the dehumidifier. (see fig. 3).
1.Using two hands gently remove lid
from the top of the bucket.
lid
1.Using two hands gently remove lid
from the top of the bucket.
lid
Bucket
Bucket
Fig. 2
Fig. 3
2.Remove casters 3.Re-install the lid and be
from bucket sure that it is securely
clipped into the bucket
2.Remove casters
from bucket
Buckle
1.Using two hands gently remove lid
from the top of the bucket.
Hole
Buckle
lid
Bucket
Fig. 1
Important Note: Verify the plastic float
system on the top of the bucket is still
securely installed and swinging properly
before placing bucket back in the
dehumidifier
3.Re-install the lid and be
sure that it is securely
clipped into the bucket
2.Remove casters
from bucket
Hole
Important Note: Verify the plastic float
system on the top of the bucket is still
lid
securely installed and swinging properly
before placing bucket back in the
dehumidifier
3.Re-install the lid and be
sure that it is securely lid
clipped into the bucket
Buckle
Float
Hole
Float
Page 7
Important No
system on the
securely insta
before placin
dehumidifier