Mitsubishi Electric RMF-CA200-V2 Installation Instructions Manual

RMF-CA200-V2
Installation / Instruction Manual
Contents
1.0 Parts .................................................................................................................................................. 1
1.1 Supplied Parts ................................................................................................................................... 1
1.2 Optional Parts ................................................................................................................................... 1
2.0 Safety Precautions ............................................................................................................................ 1
3.0 Installation ........................................................................................................................................ 2
3.1 Single Stage and Two-Stage Conventional Connection Diagram ...................................................... 2
3.2 Heat Pump Mode Connection Diagram ............................................................................................ 3
3.3 DIP Switch Settings. ........................................................................................................................... 3
4.0 System Configuration ........................................................................................................................ 4
5.0 Operation Instruction ........................................................................................................................ 5

1.0 Parts

1.1 Supplied Parts

RMF-CA200-V2 thermostat interface (1), Manual (1)

1.2 Optional Parts

24VAC Transformer (ULP24-210) sold separately from Mitsubishi Electric

2.0 Safety Precautions

THOROUGHLY READ THE FOLLOWING SAFETY PRECAUTIONS BEFORE EACH USE OF THIS PRODUCT (THE "DEVICE").
WARNING - INCORRECT HANDLING MAY RESULT IN INJURY, MALFUNCTION AND / OR DAMAGE TO DEVICE
Do not expose the device to or immerse the device in water. Doing so could lead to electrical shock, device malfunction or damage.
•
Do not install the device in a bathroom, kitchen, or any room where steam could form. Condensation could develop on or around the
•
device and cause electrical shock, device malfunction or damage.
Do not install the device in a location where a gas leak could occur.
•
Do not expose the device to heat or radiation, including direct sunlight, or install the device in a location where the temperature could
•
be greater than 40°C (104°F) or less than 0°C (32°F). Doing any of these things could result in device deformation or malfunction.
Always ensure the device is installed in an area without exposure to high frequency noise.
•
Power generators, inverters, and high-frequency or radio communication equipment may interfere with the operation of this device.
•
All electrical work should be performed by a qualified technician and in accordance with applicable laws and the instructions outlined in
•
this manual.
Use standard wiring with the proper current capacity to avoid current leak, excessive heat, and fire.
•
Use only specified cables and wiring; securely connect each so that the terminals do not bear any weight.
•
Include slack in the power supply wiring. Tension in the wiring may cause it to excessively heat up and break, which could result in a fire.
•
Improperly connected or short-circuited cables or wiring may produce heat and cause device malfunction, device damage, and fire.
•
Capacity shortage to the power supply circuit or improper installation may result in electrical shock or fire.
•
• Do not modify or alter this device or cable in any manner whatsoever.
IM-RMF-CA200-V2-202306FM
Read prior to installing / operating device. Retain for future reference.
-
© Mitsubishi Electric Sales Canada Inc. All rights reserved.
1