BIONAIRE BAP9240 - Air Purifier With HEPA-Type Replaceable Filter Manual

DESCRIPTIONS

1. Rear Grill
2. Control Panel
3. Speed Knob
4. Top Housing
5. Bottom Housing
6. Grill Frame
7. Front Grill
8. Filter Reset Button
9. Filter Light Ring
10. Ioniser Button
11. Ioniser Light Ring

HOW THE DEVICE WORKS

Dirty, dust laden air is drawn through the front of the air purifier and through the multi-stage filtration system.

1. The washable foam pre-filter captures larger particles and extends the HEPA-type filter's replacement cycle.
2. The HEPA-type filter entraps 99% of all smaller visible and non-visible particles down to 2 microns in size.
3. The independent ioniser naturally improves performance and helps freshen the air.

PRODUCT FEATURES

High, Medium and Low settings

For optimum air filtration, operate your air purifier continuously on the Medium (2) setting. Its rugged motor has been designed to give many years of use. For quieter operation (such as in a bedroom), select the Low (1) setting. When high levels of air pollution are present, select the High (3) setting.

Filter Service Indicator

The filter service indicator eliminates guesswork by letting you know when it is time to replace the HEPA-type filter. The filter light ring (I) will illuminate when it is time to replace

the HEPA-type filter. After the filter has been replaced, reset by pressing down three seconds on the filter reset button (H). Note that the filter light ring will blink three times when the unit is turned on and after being reset.

Dual position

The unit can be placed either upright or on its side, flush against the wall. When positioning the unit be sure that the air inlet grill, filters and air outlet grill are not blocked, to ensure maximum air flow.

Ioniser

This appliance has an independent ioniser feature which, when turned on, releases negative ions into outgoing filtered air to help the air purification process.

What Are Ions?
Ions are tiny particles that carry a positive or negative charge. They exist naturally around us: in the air, water, and ground. Both positive and negative ions are colourless, odourless, and completely harmless.

How Does The Ioniser Work?
Negative ions help air purification by attaching themselves to very small airborne particles in the room. These particles take on a negative charge and may join with positively charged particles such as dust, pollen, smoke, and pet dander to form larger particles. The larger particles are then more easily captured by the filter system.

Important Notes:
Your ioniser may produce an occasional popping or cracking sound. This is normal and occurs when a small buildup of ions is discharged.

After extended use, you may notice dust around the grills or front panel.

• This is caused by negative ions exiting the air outlet, evidence of the ioniser's air cleaning effectiveness.
• You can remove the dust with a soft brush or clean, damp cloth.
  Larger particles may be attracted to positively charged surfaces throughout the home, like walls or floors.
• This may occur more frequently when the filter is nearing the end of its useful product life and unable to capture as many charged particles.
• Excessive amounts of pet dander, dust, or smoke may decrease the life expectancy of the filter(s) and interfere with the ionisation process.
  To help prevent particles from attracting to surfaces throughout your home:
• You may want to run the ioniser less often. *tested and listed by the Underwriters Laboratories, Inc.
• Check the condition of the filter(s) more frequently.

The ioniser in this appliance produces less ozone than the UL* established limits of 50ppb. However, in high concentrations, ozone can be harmful to birds and small pets. To prevent ozone buildup, we suggest using the ioniser in well ventilated areas with the fan on.

PLEASE NOTE: It is important to change the HEPA-type filter at recommended intervals. Using the ioniser in conjunction with dirty filters may result in dirty particles exiting the air purifier and being attracted to walls, carpets, furniture and other household objects. These dirty particles may prove very difficult to remove.

PRE-OPERATING INSTRUCTIONS

1. Carefully unpack your air purifier.
2. Select a firm level place where there are no obstructions to the air inlet (front grill) or filtered air outlet (top of the unit).

OPERATING

1. Plug into a suitable 220 – 240V electrical outlet.
2. Select the required operating speed: High (3), Medium (2), Low (1) by turning the knob.
3. To release negative ions into the filtered air, press the ioniser button () and the light will illuminate.

CLEANING AND MAINTENANCE

1. Turn the air purifi er off and unplug it before cleaning.
2. The outside of the air purifi er can be cleaned with a soft, clean dampened cloth.
3. The filtered air outlet on the top of the unit can be cleaned of dust with a small, soft brush.
4. If you wish to clean the inside of the air purifi er, please only use a dry, soft cloth to wipe it down.

FILTER REPLACEMENT

IN ORDER TO RETAIN THE EFFICIENCY OF YOUR AIR PURIFIER, THE HEPA-TYPE FILTER NEEDS TO BE CHANGED EVERY 3-6 MONTHS. THE FILTER LIGHT RING (I) WILL ILLUMINATE WHEN IT IS TIME TO REPLACE THE HEPA-TYPE FILTER.

1. Every few weeks check the condition of the pre-filter.
2. Remove the front grill via the latch on the bottom. If the foam pre-filter has collected a noticeable amount of dust, remove it from the inlet of the grill and wash it in warm soapy water. Rinse and dry the pre-filter thoroughly before replacing it in the inlet of the grill.
3. With the front grill removed, remove the HEPA-type filter and dispose in the dust bin. DO NOT try to wash and re-use the filter. Replace with a new HEPA-type or True HEPA filter, removing the protective plastic bag before inserting into the air purifi er.
4. Align the clips on the top of your filter with the rails on the inside of the unit. Gently slide the filter onto the rails.
5. The filter clip should easily slide onto the filter hang tabs. Do not use force while attaching the filter clip to the filter.
   Align the clip on the top of your filter with the rails on the inside of the unit.
   NOTE: The pleated material and rubber gasket should be facing towards the unit when applied.
6. Replace the front grill by positioning the bottom and then snapping back on to the unit. Make sure that it fits securely into position (the grill only goes on one way).
   NOTE: Do not point outlet towards wall.
7. The filter service indicator should be reset once the filter has been replaced. Reset by pressing down three seconds on the filter reset button (H).

REPLACEMENT FILTERS:
BAPF30B HEPA-type filter
BAPF300 True HEPA filter -- Helps remove up to 99.97% of airborne particles as small as 0.3 microns, including tobacco smoke.

UK - Filter Sales Order Line - 0870 759 9000

FOR U.K. AND IRELAND ONLY
If the plug is not suitable for the socket outlets in your home, it can be removed and replaced by a plug of the correct type. Please refer to "Installation of a plug" below.

Installation of a plug applicable to UK and Ireland only

NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about the installation of the plug please contact a qualified electrician.
If a 13A 3-pin plug is fitted, it must be an ASTA approved plug, conforming to BS1363 standard.
Replacement 3A fuses must be BSI or ASTABS1362 approved.
This product is fitted with a 13A plug complying to BS1363. If this plug is unsuitable or needs to be replaced, please note the following: The wires in the mains lead are coloured as such:
BROWN - LIVE
BLUE - NEUTRAL
Please note that the colour of these mains wires may not correspond with the colour markings that identify the terminals in your plug. Please proceed as follows:
The BROWN coloured wire must be connected to the terminal, which is marked with the letter "L" or is coloured RED.
The BLUE coloured wire must be connected to the terminal, which is marked with the letter "N" or is coloured BLACK.
DO NOT CONNECT either of these wires to the earth terminal in the plug. The earth terminal plug is marked with the letter "E", or with the earth symbol , or coloured GREEN, or GREEN and YELLOW.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download BIONAIRE BAP9240 - Air Purifier With HEPA-Type Replaceable Filter Manual