Installing Your Edge Gateway; Professional Installation Instructions - Dell N03G Installation And Operation Manual

Installing your Edge Gateway

WARNING: Before you begin any of the procedures in this section, read the safety information that shipped with
your system. For additional best practices information, go to www.dell.com/regulatory_compliance.
WARNING: The Edge Gateway is to be installed by knowledgeable, skilled persons familiar with local codes and
regulations.
WARNING: The Edge Gateway is not designed for use in wet environments. If the Edge Gateway is to be installed
in a wet environment, it must be installed in a panel box or enclosure with an Ingress Protection (IP) rating of IP54,
IP65, or higher, depending on the location and environment.
WARNING: To reduce the risk of electric shock, power to the DC+ and DC- terminals must be provided by a power
supply or transformer/rectifier circuit that is designed with double-insulation. The power supply or power circuit
source must comply with local codes and regulations; for example, in the USA, NEC Class 2 (SELV/limited energy
circuit, or LPS circuitry). Note that if powered by a battery, double-insulation is not required.
WARNING: When installing the Edge Gateway, the responsible party or integrator shall use the 12-57 V DC or
Power over Ethernet (PoE) power source already present as part of the client's installation.
WARNING: When installing the Edge Gateway, use a cable appropriate for the load currents: 3-core cable rated 5
A at 90°C (194 °F) minimum, which conform to either IEC 60227 or IEC 60245. The system accepts cables from 0.8
mm to 2 mm. The maximum operating temperature of the Edge Gateway is 70 ⁰ C (158°F). Do not exceed this
maximum temperature while operating the Edge Gateway inside an enclosure. Internal heating of the Edge
Gateway electronics, other electronics, and the lack of ventilation inside an enclosure can cause the operating
temperature of the Edge Gateway to be greater than the outside ambient temperature. Continuous operation of the
Edge Gateway at temperatures greater than 70 ⁰ C (158°F) may result in an increased failure rate and a reduction of
the product life. Ensure that the maximum operating temperature of the Edge Gateway when placed inside an
enclosure is 70 ⁰ C (158°F) or less.
WARNING: The symbol
normal use that can cause a burn. Allow equipment to cool off or use protective gloves when handling to reduce
risk of a burn.
WARNING: Always ensure that the available power source matches the required input power of the Edge
Gateway. Check the input power markings next to power connector(s) before making connections. The 12-57 V DC
or PoE power source must be compliant with local Electrical Codes and Regulations.
WARNING: To ensure the protection provided by Edge Gateway is not impaired, do not use or install the system in
any manner other than what is specified in this manual.
WARNING: If a battery is included as part of the system or network, the battery must be installed within an
appropriate enclosure in accordance with local fire and electrical codes and laws.
WARNING: The system is for installation in a suitable industrial enclosure (provides electrical, mechanical, and
fire hazard protection).
WARNING: The core module only can be wall-mounted (without the need for an additional enclosure).

Professional installation instructions

Installation personnel
This product is designed for specific applications and needs to be installed by qualified personnel with RF and
regulatory-related knowledge. The general user shall not attempt to install or change the setting.
10
indicates hot surface or adjacent hot surface that can obtain temperature during
3