Licenses; Diagnostics - Bosch MIC-7230-PB4 Operation Manual

MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
3.
4.
Once the upload is complete, the new configuration is activated. The time remaining is shown
by the message going to reset Reconnecting in ... seconds. The unit reboots automatically
once the upload has successfully completed.
Download
1.
2.
Configuration
You can save configuration data for the camera on a computer and then load saved
configuration data from a computer to the unit.
SSL certificate
To be able to work with an SSL encrypted data connection, both ends of a connection must
hold the relevant certificates. You can upload the SSL certificate, comprising one or multiple
files, onto the camera.
If you wish to upload multiple files onto camera, you must select them consecutively.
1.
2.
3.
The new SSL certificate is valid.
Maintenance log
You can download an internal maintenance log from the unit to send it to Customer Service
for support purposes. Click Download and select a storage location for the file.
15.53

Licenses

You can enter the activation key to release additional functions or software modules.
Notice!
The activation key cannot be deactivated again and is not transferable to other units.
15.54

Diagnostics

BIST
Accesses the Built-in Self Test (BIST). The BIST displays a Pass or Fail status on the most
recent homing event.
Click the Start BIST button to initialize the BIST.
Logs
This section updates automatically with the history of the camera and maintains a log of all
events such as those listed below. Click the REFRESH button to reload log data.
–
–
Bosch Security Systems, Inc.
Next, click Upload to begin transferring the file to the unit. The progress bar allows you to
monitor the transfer.
Click OK to the warning message to continue the firmware upload, or Cancel to stop the
upload.
The page displays a progress bar as the firmware is uploaded.
Note: Once the progress bar reaches 100%, the system opens the reset page. Allow the
reset page to complete its action.
Click the Download button. A dialog box opens.
Follow the on-screen instructions to save the current settings.
Enter the full path of the file to upload or click Browse to select the required file.
Next, click Upload to begin transferring the file to the unit.
Once all files have been successfully uploaded, the unit must be rebooted. In the address
bar of your browser, enter /reset after the IP address of camera (for example
192.168.0.10/reset).
Low voltage - a drop in incoming power below the level where the camera becomes non-
functional
High temperature - the internal temperature exceeds specifications
Operation Manual
Configuration via IP, Advanced Mode | en
2014.05 | 1.0 | F.01U.291.520
87