Advertisement
4. ASSEMBLY
Refer to fig.1
4.1.
Fit axle into base assembly, line up holes the two holes.
4.2.
Fit lower handle assembly over base and axle assembly. Use long screws, washers (each side) and spring washers to bolt through all
three parts. Tighten screws.
4.3.
Fit the upper section of the handle, tighten thumbscrew.
4.4.
Fit the front wheel. Insert the sleeve into the front wheel. Insert the pin through the front extenson of the frame, through the wheel and
through the other side of the frame. Secure with washers and 'R' pins each end.
4.5.
Fit the rear wheels, secure with washers and 'R' pins.
4.6.
Insert the pole (without the end bung), then the pole with the end bung on top.
4.7.
There is a choice of spacing of the wheel supports. Insert the lowest support pin and place a support on top. Make sure the pin locates
into the support's cut outs. Fit the three remaining pins and supports in the same way, see fig.2.
5. OPERATION
WARNING! Ensure that you read, undersand and apply Section 1 assembly instructions.
‰
WARNING! If only loading only one or two wheels DO NOT load them on the upper section. This will affect the stability of the trolley
‰
and may cause damage and/or injury.
5.1.
Make sure path to the storage location is level, clear and free from debris.
5.2.
Release brakes on all four wheels and reapply brakes once rack is in its desired location.
5.3.
When not in use, store assembled in a safe, dry, childproof location.
6. MAINTENANCE
6.1.
Keep the trolley clean.
6.2.
Periodically oil the castors.
Fig.1
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Fig.2
Environmental Protection
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
Original Language Version
INTENANCE
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
STR005 | Issue 1 18/11/15
Advertisement
