American Gas Lamp Works GLM36 BOULEVARD Installation

VENTILATOR
DOME
RING ASSEMBLY
BURNER ASSEMBLY
GLOBE
BOTTOM FITTER
YOKE
POST INSTALLATION (for standard burial steel or aluminum post)
1. Obtain from your dealer 3" OD post with notches for valve access at top.
2. Install inside post (1/4" OD) gas feed line tubing with ¼" flare nuts at each end. Tubing should be coiled 2 ½ times at
top.
3. Tubing should protrude about 5" through the access hole at the bottom of post.
4. If supplied, insert ladder rest through hole and attach ornamental ball to each end.
5. Dig a hole 21" deep X 12" wide.
6. If a pedestal base is being used proceed to step 7, if no base is being used attach the ¼" flare nut from the gas feed line at
the bottom of the post to the main gas supply and secure post in plumb position, pour concrete around the post to just
below the level of the line access hole. Back fill the hole.
7. If using a pedestal base, pour the concrete in the hole, place the pedestal base over the hole and slide the post down
through the center of the base into the concrete leaving the access hole just above the concrete line. Attach the ¼" flare
nut from the gas feed line at the bottom of the post to the main gas supply and secure the post in plumb position. Back fill
the hole and push the base about 1"-2" down in the ground and secure in place using the back fill. If the base is not
secured in the ground, the freeze and thaw of the ground can cause the base to rise and fall causing the finish of the post
to scratch.
LAMP INSTALATION
1. Feed tubing through yoke and connect ¼" flare nut to the brass connector at bottom of burner assembly. (loosen front
setscrew beneath the bottom fitter to slide burner out for connection).
2. Lower lamp onto post.
3. Tighten setscrews in bottom of yoke to secure lamp to post.
4. With the valve in the off position ( ), turn on main gas supply and check all gas connections for leaks, using a soap
solution. If air bubbles appear, shut off main gas line and tighten all fittings.
5. NEVER USE AN OPEN FLAME TO CHECK FOR GAS LEAKS!
LIGHTING INSTRUCTIONS (ON BACK)

GLOBE / DOME INSTALLATION

1. Open ring assembly and place globe down through until it rests on the inner ring assembly (careful not to touch burning
mantles). If the globe is not resting on the bottom fitter, loosen the (2) back setscrews beneath the bottom fitter and slide
it up until the globe sits secure. (tighten set screws to secure bottom fitter) (DO NOT loosen the single front set screw
while your burner is lit, this one holds the burner in place).
2. Close the outer ring assembly and secure with latch.
3. Place dome on top of ring assembly and tighten knurled screws to hold dome in place.
4. Place ventilator assembly on top of dome and tighten knurled screws to hold ventilator in place.

MAINTENANCE INSTRUCTIONS

No combustible material, gasoline or other flammable vapors or liquids should be stored near lamp. Nothing should obstruct the
flow of combustion and ventilation air. Occasionally the glass will need to be cleaned with household glass cleaner and mantles
should be visually checked, for condition and burn, replace mantles if necessary. Gas lamp parts and mantles are available from
your local gas appliance dealer or AMERICAN GAS LAMP WORKS
GLM36 BOULEVARD
AND
GLM42 VICTORIAN
The lamp head must be installed to conform with
the local codes, or in absence of local codes, with
the national fuel gas code ansi Z223.1-latest edition,
CAN 1-B149.1 or CAN 1-B149.2
FOR OUTDOOR USE ONLY
7" Water Column for Natural Gas
11" Water Column for LP