Table of Contents
Advertisement
SUP-1158S User Manual
50.56
In order to revised the flow exceed the scope of the above table, without mutations of correction factor,
we add two points on the basis of the above five points, (0 m
1.0) is called the minimum flow of the amendment point, this set of data is used to facilitate to
generated a appropriate correction factor when Instrumented show flow under 1.02 m
1.0) is called the maximum flow of the amendment point, this set of data is used to facilitate to
generated a appropriate correction factor when Instrumented show flow above 50.56 m
get the following data sets from small to large.
( 0
,
( 0.0998
,
( 5.505
,
( 10.85
,
( 19.78
,
( 51.23
,
( 100000
,
The total is seven sets of data. The next step is to put seven sets of data entered into the Instrument.
Pay attention to the input order in accordance with from small to large.
To enter the menu M48, then input the data set number "7", to be followed in the above seven sets of
data, we revised the setup of a multi-segment linearity correcting.
If you need to cancel linearity correcting, simply enter "0" in the menu M48.
Decommissioned linearity correcting, you just need to enter in the menu M48 data points (in this case,
is "7").
Noted: before the calibration of the instrument, you must first close the linearity correcting function. If
under the condition that the linearity correcting function has not closed, the calibration data sets arising
from the amendment must be dealing with the reverse curve of the data following the original
amendment, then input to the Instrument. Reverse amendment is very complicated, and should be
avoided.
4.37 How to save / restore frequently-used pipe parameters
You can use menu window 27 to store or restore from the internal Flash memory, as many as 9
different pipe parameter configurations.
51.23
1
)
1.02
)
0.93 )
0.95 )
1.03 )
0.99 )
1.
)
35
/h, 1.0) and (100000 m
3
35
0.99
/h, 1.0). (0 m
/h,
3
3
/h. (100000 m
/h,
3
3
/h. So that we
3
Advertisement
Table of Contents
Need help?
Do you have a question about the SUP-1158S and is the answer not in the manual?
Questions and answers