Connecting Loudspeakers - Genelec 4410A Operating Manual

CONNECTING LOUDSPEAKERS

To get started, connect an Ethernet cable from the PoE+ output of an IP switch
to the 4410A Ethernet port. Use at least CAT5 cable or better. Press the power
switch to power up the loudspeaker.
To create a working system, you will need
•
IP switch with a PoE+ (802.3at) output for the 4410A loudspeaker
or an IP switch with no PoE support and a PoE+ power injector
•
CAT 5 or higher category Ethernet cable with RJ45 connectors
•
AES67, ST2110 or Dante audio-over-IP stream source
•
For 4410A setup and configuration, a computer running Windows 10
operating system
•
Genelec Smart IP Manager software
•
Dante Controller software or Dante Domain Manager software
Figure 3. 4410A powered with PoE+ IP switch.
An example of powering the 4410A with a PoE+ enabled IP switch. With this
method, the power budget available for all outputs connected to the IP switch
must enable each 4410A to run at full PoE+ power. For 4 loudspeakers, the
power supply must support 4 x PoE+ power level.
4