Plantronics Pulsar 590 User Manual
Stereo bluetooth headsets
Hide thumbs
Also See for Pulsar 590:
- User manual (14 pages) ,
- Manual (9 pages) ,
- Specifications (2 pages)
Related Manuals for Plantronics Pulsar 590
Summary of Contents for Plantronics Pulsar 590
- Page 2 If you need further assistance please contact Plantronics at (866) 363-BLUE (2583). Troubleshooting information can be found on page 13 and also on the web at www.plantronics.com/support. Please do not return the product to the store where it was purchased.
-
Page 3: Package Contents
PACKAGE CONTENTS... - Page 4 FEATURES...
- Page 5 FEATURES...
- Page 6 Note: Charge for 3 hours before first use. 1. Connect AC charger to desktop charging stand and universal adapter. 2. Lift and position earpieces inside headband foam ear cushions face each other. 3. Place headset into desktop charging stand. Headset indicator light flashes when charging.
- Page 7 POWERING Slide power switch up for “on” and down for “off.” To turn on, rotate dial counterclockwise so solid dots are aligned. To turn off, rotate dial clockwise until the open dot and solid dot are aligned.
- Page 8 Pairing with Bluetooth Begin with headset turned off. 1. Press and hold the call control button. 2. Power headset on and when the indicator light flashes red and blue, release the call control button. For set up and pairing instructions with Bluetooth devices other than mobile phones, please consult your Bluetooth device user guide.
- Page 9 NOTE: The Pulsar 590A headset is paired with the universal adapter at the factory. If adapter and headset continue to flash red rather than blue, connect or pair them again. To reconnect, press the adapter pairing/connect button. To pair again, follow directions below.
-
Page 10: Adjusting Fit
ADJUSTING FIT Position headset so that telescoping voice tube is on right ear. Adjust headband if necessary. Point tip of telescoping voice tube toward mouth and extend for optimal voice transmission - may require two hands. - Page 11 IN-FLIGHT AND WIRED USES In-flight cable can be used with any 3.5mm audio jack to convert your wireless headset into wired headphones. Headset will not operate when in-flight cable is connected and headset is powered on. 1. Power headset off.
-
Page 12: Headset Controls
HEADSET CONTROLS... - Page 13 HEADSET CONTROLS...
-
Page 14: Troubleshooting
TROUBLESHOOTING... -
Page 15: Product Specifications
PRODUCT SPECIFICATIONS TECHNICAL ASSISTANCE REGULATORY NOTICES... - Page 16 © 2005 Plantronics, Inc. All rights reserved. Plantronics, the logo design, Pulsar and Sound Innovation are trademarks or registered trademarks of Plantronics, Inc. The Bluetooth name and the Bluetooth trademarks are owned by Bluetooth SIG, Inc, and are used by Plantronics, Inc. under license.
Need help?
Do you have a question about the Pulsar 590 and is the answer not in the manual?
Questions and answers