Honeywell Home ADEMCO C6160RF User Manual

KEYPAD DISPLAYS AND LEDS

The 6160RF has the following features:
• Large backlit, 2-line, 32-character alphanumeric LCD.
• 16 large telephone-style backlit keys located behind a
decorative door that swings down to provide access to
the keys.
• System numerals, imprinted in large type on the keys for
easy identification. System functions appear below the
keys on the keypad.
The following table shows the LEDs and their functions:
LED
ARMED Lights when the system is armed in any mode.
(Red)
READY Lights when the system is ready to be armed (no
zone faults are present).
(Green)

FUNCTION KEYS AND LABELS

The function keys are continuously backlit for ease in use.
(Check the User Guide that accompanies the control panel
for detailed instructions on the use of these keys.)
Function Keys - The function keys include keys for panic
alarm activation. The panic alarms are activated by
pressing key pairs [1] & [*], [3] & [#], or [*] & [#], or a
Special Function Key.

TROUBLESHOOTING

The error messages listed in the following table cause the keypad to produce a single ding tone. The table describes the error
messages and the corrective actions.
Display
Low Bat (with Zone No.)
Open Ckt
Check 100
Function
ARMED
READY
SPECIAL
FUNCTION
KEYS
PANIC KEY PAIR
6160RF Keypad/Transceiver (front door removed)
1. Replace the battery if the wireless transmitter has a replaceable battery.
2. Replace the transmitter if the wireless transmitter does not have a replaceable battery.
Contact your Installer.
Contact your Installer.
User Guide
Whether these panic keys function and the type of panic
alarms they produce is determined by the control panel's
capability and programming. (Check with your installer for
the availability and type of alarm of these panic keys.)
Special Function Keys - These are the four keys located
to the left of the numeric keys (see below). The keys may
be programmed by your installer for panic alarms or other
special functions such as single-button arming (Check with
your installer to see which options are available with your
system.)
Special function keys and function key pairs must be
held down for at least 2 seconds to activate an alarm.
A set of adhesive labels with typical panic symbols is
provided. Place the appropriate label in the indented area
on each key, so that the user can easily identify each
key's function.

SOUNDER

The built-in speaker has the following functions:
• Produces warning sounds during alarm and trouble
conditions, and also during entry/exit delay periods.
Provides acknowledgment tones when keys are pressed,
and confirmation tones for successful command entries.
OFF AWAY
" #
MAXIMUM TEST
% &
INSTANT CODE
0
READY
PANIC KEY PAIR
Corrective Action
ADEMCO 6160RF
Keypad/Transceiver
!
STAY
$
PANIC
KEY
BYPASS
'
PAIR
CHIME
#
6160RF-001-V1