Husqvarna DE 110 SH Operator's Manual page 18

3. Discard the plastic bag correctly. Refer to local
regulations.
4. Install the new prefilter.
If the suction is not sufficient when a new prefilter is
installed, it is necessary to replace the HEPA filter. Refer
To replace the HEPA filter on page 18 .
to
To replace the HEPA filter
The HEPA filter cannot be cleaned. It is always
necessary to replace it with a new HEPA filter. Only use
HusqvarnaHEPA filters.
WARNING:
center or an approved authority is permitted
to replace the HEPA filter.
WARNING:
protective equipment, refer to
protective equipment on page 7 .
WARNING:
filter are dangerous to your health.
WARNING:
no holes in the HEPA filter. A damaged
HEPA filter is a health risk.
WARNING:
filter. If you install a used HEPA filter,
leakage and decreased filtration efficiency
can occur.
CAUTION:
surface of the HEPA filter. This can cause
damage to the HEPA filter.
1. Loosen the 6 screws and remove the HEPA filter
cover.
18
Only an approved service
Always use personal
Personal
The particles in the HEPA
Make sure that there are
Do not install a used HEPA
Do not touch the inner
2. Attach the dust cap (A) and pull out the HEPA filter.
Put it into a clean plastic bag (C).
A
B
3. Discard the plastic bag correctly. Refer to local
regulations.
4. Install a new HEPA filter. Make sure that the HEPA
filter is pushed to the end position.
5. Install the HEPA filter cover and tighten the 6
screws.
C
1587 - 011 - 06.03.2023