Keypad Mode Setup - CIGNUS CG-828UV User Manual

51
Press the Main band selector knob or
back to function menu. Press
0.5 second to store setup and exit.
After the above setup, hold microphone PTT key and [ DOWN ] key, the
radio will transmit selected tone.
NOTE

keYpAd Mode Setup

11
Press key to enter function menu.
21 Turn the Main band selector knob to
choose No.20 menu. The LCD displays
"KEYMOD".
31
Press the Main band selector knob to enter function setup.
41 Switch the Main band selector knob to choose wanted mode.
KEY1: key1 mode, Normal mode, the left 4 keys have same functions
as the right 4 keys.
KYE2: the left 4 keypads will shared by
both band. And the right 4 key
pads will be re-defined.
51
Press the Main band selector knob or
back to function menu. Press
0.5 second to store setup and exit.
Notice: Definition of Keypad in KEY2 mode:
11
Left Short press: In VFO mode, short press this key,
the frequency step size changes to 1Mhz, in channel mode,
adjust selector knob will jump 10 channels.
21
Right long press: In standby, long press this key to
add/delete optional signaling, repeat the long press it will
set optional signaling DTMF, 5TONE or 2TONE. When the
key to store value and
key or hold selector knob for over
key to store value and
key or hold selector knob for over
General Setting
LCD displays DT means DTMF, displays 5T means 5TONE,
displays 2T means 2TONE.
31 Right band long press: Talk Around. When this function
is activated, transceiver can not communicate with repeater.
The transceiver will transmit by RX frequency with its
CTCSS/DCS signaling. Repeat the operation to turn off Talk
Around.
41
Right short press: Frequency reverse function, when
current channel is setup with offset direction and offset
frequency, press this key will turn on frequency reverse
function. When frequency reverse function is on the TX
frequency turns to RX frequency & RX frequency changes to
TX frequency. The signaling will also be reversed if CTCSS/
DCS signaling existed in this channel. Repeat the short
press it will turn off Frequency reverse function.
51
Right long press: In stand by, hold this key until the
LCD displays , means the compander function is on,
repeater above operation to turn off compander function.
61
Right short press: In standby, press this key to set the
CTCSS/DCS code for current channel.
When the LCD displays ENC, the current channel is with
CTCSS encode function.
When the LCD displays ENC and DEC, the current channel
is with CTCSS /DCS code function.
When the LCD displays DCS and DCS icon, the current
channel is with CTCSS code function.
When the LCD displays OFF, the current channel is without
CTCSS /DCS function.
71 Right long press: In standby, long press this key to
enter CTCSS/DCS scan, when find matching CTCSS/DCS
signal, the scan will pause in the way following Scan Dwell
7
22