Husqvarna V554 Operator's Manual page 22

9. Install the deck drive belt. Refer to
deck drive belt on page 21 .
To remove the pump belt
1. Remove the deck drive belt. Refer to
the deck drive belt on page 21 .
2. Remove the clutch stop to get access to the
pump belt.
3. Disconnect the clutch wire.
4. Remove the belt from the engine and the pump
pulleys.
To install the pump belt
1. Put the pump belt around the pulley on the
engine and then around the left pump pulley.
2. Put the pump belt around the inner side of the
idler pulley.
3. Move the idler pulley back and hold it and put the
pump belt around the right pump pulley.
4. Install the clutch stop.
5. Install the deck drive belt. Refer to
deck drive belt on page 21 .
6. Do a check of the tension of the pump belt. The
recommended tension of the pump belt is 27 lb /
12.25 kg.
7. Turn the nut on the eye bolt on the idler pulley to
adjust the tension of the pump belt.
To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2. Pull open the operator cushion to get access to
the engine.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick in the hole for the dipstick and
tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
22
To install the
7. The oil level must be between the marks on the
To remove
8. Fill the oil through the hole for the dipstick. Fill
9. Tighten the dipstick fully before you start the
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the
engine oil warm and faster to drain.
To install the
1. Park the product on level ground and stop the
2. Pull open the operator cushion to get access to
3. Remove all dirt around the oil cap.
4. Open the oil cap and remove the dipstick.
5. Put the oil drain hose through the hole in the
dipstick. If the level is near the ADD mark, fill oil
to the FULL mark.
the oil slowly.
Note:
Technical data on page 29
Refer to
for the types of engine oil that Husqvarna
recommends. Do not mix different types of oil.
engine.
WARNING:
engine for more than 1–2 minutes before
you drain the engine oil. The engine oil
becomes very hot and can cause burn
injuries. Let the engine become cool
before you drain the engine oil.
WARNING:
your body, clean with soap and water.
engine.
the engine.
frame.
Do not operate the
If you spill engine oil on
1995 - 002 - 05.12.2022