tams elektronik 30 plus Series Manual page 85

Locomotive decoders of the series 30 plus
Possible cause: The magnet has been mounted incorrectly polarized.
 Alter the mounting direction.
Possible cause: The function has been assigned incorrectly to the
switching input.  Check the settings in CV## 61 to 64 and 177 and
178.
Problems with the sound playback

There is no sound to be heard after switching on.
Possible cause: The loadspeaker has been connected incorrectly.
 Check the connections.
Possible cause (LD-G-36 plus only): The sound level has been set too
low in CV#902.  Check the settings.
Possible cause: The decoder is incorrectly connected to the SUSI
interface of the sound module.  Check the connections.

The sound playback is bad, the loudspeaker hums, you can hear
disturbing noises.  Mount a buffer capacitor and a suppression choke.
Problems with switching the servo

The servo does not move.
Possible cause: The left and the right stop are defined incorrectly.
 Check the settings in CV##169 and 170.
Possible cause: The servo has been mounted incorrectly.  Check
the connections.
Possible cause: The power supply is connected incorrectly  Check
the connections.
Problems with the POM-Update

While updating the decoder the lighting starts to flash, the update is
interrupted.
Possible cause: The settints for the POM-Update are wrong.
à Check and alter the settings if necessary. The helpfile contains
explanations.
English
Page 85