Husqvarna 1-10DS Operator's Manual page 13

2. Push the abrasive control lever (A) to close the
abrasive valve. Push the OFF button (B) to stop the
blastmotor.
3. Set the movement speed to the lowest possible,
approximately 0.5.
4. Open the drive chain cover.
2070 - 003 - 16.03.2023
5. Install the quick release pin. Push and hold the quick
A
B
6. Use your other hand to operate the drive system
7. Close the drive chain cover.
8. To disengage the drivesystem, pull out the quick
release pin with a finger.
lever.
The quick release pin locks into position when the
drive system is engaged.
release pin.
13