Connection; Connecting To Monitor; Connecting To Power - Samsung SCD-2080N User Manual

Installation
Adjust the panning and tilting, rotating while watching the monitor
174˚
176˚
Pan Base
1) You can adjust camera to any direction by using Pan, Tilt, Rotate mechanism.
• Pan Base moves by 176˚ to each side direction and 352˚ on the whole.
• Tilt Base covers total 73˚ angle(0˚ ~ 73˚).
• R otate Base moves by 174° to each side direction and 348° on the whole.
2) Methods of adjustment
•
The case of wall installation
After mounting the camera on a wall, adjusting the panning angle so that the camera can
... 1
face the direction to monitor when tilted.
Adjust the tilting angle by rotating the tilt base.
... 2
Loosen the rotate base hold screw and adjust rotate base for the best view.
... 3
Tighten the rotate base hold screw.
... 4
•
The case of ceiling installation
After mounting the camera on a ceiling, adjusting the panning angle to the correct viewing
... 1
position by rotating the pan base.
Adjust the tilting angle by rotating the tilt base.
... 2
... 3 Loosen the rotate base hold screw and adjust rotate base for the best view.
Tighten the rotate base hold screw.
... 4
COLOR DOME CAMERA
73˚
Rotate Base
Tilt Base
12
User Guide

Connecting to Monitor

Connect the Video Output jack to the VIDEO-IN jack of monitor.
CCTV Camera
• As the connecting method varies with the instruments, refer to the manual supplied with the
instrument.
• If necessary, you can connect the monitor to the REMOTE jack on the back of your camera.
• Only connect the cable when the power is turned off.

Connecting to Power

Connect the adaptor to the power input terminal as shown in the figure below. The
recommended adaptor specification for SCD-2080N/SCD-2080P is DC 12V / 500mA or AC 24V
/ 300mA.
When the resistance value of copper wire is at [20˚C(68˚F)]
Copper wire size (AWG)
#24(0.22mm 2 ) #22(0.33mm
Resistance (Ω/m) 0.078
Voltage Drop (V/m)
0.028
• As shown in the table above, voltage decreases as the wire gets longer. Therefore
use of an excessively long adaptor output line for connection to the camera may
affect the performance of the camera.
*Standard voltage for camera operation : DC 12V ± 10%, AC 24V ±10%
*There may be some deviation in voltage drop depending on the type of wire and the manufacturer.
COLOR DOME CAMERA

Connection

Monitor
---- Power Input Terminal
2 ) #20(0.52mm 2 ) #18(0.83mm 2 )
0.050 0.030 0.018
0.018 0.011 0.006
13
User Guide