Page 1
4. Press ▲/▼ to select “System”. Press OK. → The display shows the FW (firmware) version number → Upgrading is necessary if the FW version is an earlier one Note: The firmware information is also useful when you call Philips Customer Care Center. ii) Checking Wi-Fi connection...
Page 2
Wi-Fi connection with the Wireless router/Access Point (if applicable): Check the Wireless router/Access Point is working if your Center is connected to PC via a Wireless router/Access Point __________________________________________________________________ 4. Upgrading You can upgrade the embedded firmware in 2 ways Upgrading from CD-ROM Upgrading from PC A) Upgrading from CD-ROM...
Page 3
Single session • Write Speed : Low • Finalized the disc. (The application may do this automatically.) (Note: Make sure you finalize the CD) ii) Upgrade WACS57 Upgrade WAC5 Center: 1. Check WAC5 Center is on and WAS700 Station is off...
Page 4
2. On Center, insert the upgrading CD into the CD slot loader, with CD graphic printed side facing you → Upgrading starts automatically → The display shows “Updating firmware, please wait……” . A progress bar appears → Center will reboot itself twice during the upgrading process →...
Page 5
- Do not rename the filename. Visit open the .zip file. ) ii) Upgrade WACS57 Upgrade WAC5 Center: 1. Connect your PC and WAC5 Center using the supplied Ethernet cable 2. Launch the Digital Media Manager (DMM) on your PC 3.
Page 6
4. Click Yes to start upgrading 5. Find the Firmware Upgrade file you stored in the PC. Click Open...
Page 7
→ You will start transferring the file to WAC5 Center → After file transferring is finished, upgrading starts automatically on WAC5 Center → The Center’s display shows “Updating firmware, please wait……”. A progress bar appears → Center will reboot itself twice during the upgrading process →...
Page 8
Upgrade WAS700 Station: 6. Press STANDBY-ON to turn on WAS700 Station → Upgrading starts automatically → The display shows “Updating firmware, please wait……” . A progress bar appears → Station will reboot itself twice during the upgrading process → After about 5 minutes, Station returns to HD mode. The upgrading is completed (Note: - Keep your Station turned on during the upgrading.) Helpful hints:...
Page 9
6. Firmware history Version 1.2.10 • The software release 1.2.10 has provided a solution for CD ejection problem that has happened on a marginal number of CDs. Version 1.2.0 • Firmware installed on the set delivered...