D-Link DAP-1325 User Manual page 45

DAP-1325 N300 Wi-Fi Range Extender
User Manual
In the DHCP section, you can configure the built-in DHCP server of the extender. The DHCP
server is disabled by default.
Figure 39. Configuring local IP addresses. The IPv4 tab. The DHCP section.
Parameter
Mode
Start IP
End IP
Lease time
DNS Relay
When all needed settings are configured, click the APPLY button.
DHCP
An operating mode of the extender's DHCP server.
Server: the extender assigns IP addresses to clients automatically in
accordance with the specified parameters. When this value is
selected, the Start IP, End IP, Lease time fields and the DNS
Relay switch are displayed on the tab.
Disable: the extender's DHCP server is disabled, clients' IP
addresses are assigned manually.
The start IP address of the address pool used by the DHCP server to
distribute IP addresses to clients.
The end IP address of the address pool used by the DHCP server to
distribute IP addresses to clients.
The lifetime of IP addresses leased by the DHCP server. At the end
of this period the leased IP address is revoked and can be distributed
to another device, unless the previous device has confirmed the need
to keep the address.
Move the switch to the right so that the devices connected to the
extender obtain the address of the extender as the DNS server
address.
Move the switch to the left so that the devices connected to the
extender obtain the address transmitted by the ISP or specified on
the Advanced / DNS page as the DNS server address.
Page 45 of 92
Configuring via Web-based Interface
Description