Radio; Power Supply - Philips AZ2000 Owner's Manual

POWER SUPPLY

AC POWER
1. Check if the power voltage as shown on the type plate on the
base of the set, corresponds to your local power voltage. If it
does not, consult your dealer or service organisation.
2. If your set is equipped with a voltage selector, adjust it so
that it matches with the local power.
3. Connect the power cord to the MAINS outlet and the wall
outlet.
™ The power supply is now connected and ready for use.
4. To switch off completely, withdraw the power cord from the
power cord.
• Disconnect the power cord from the wall outlet to protect your
set during heavy thunderstorms.
• To avoid overheating of the set a safety circuit has been built
in. Therefore your set may disconnect under extreme
conditions. If this happens, switch the set off and let it cool
down before reusing it.
Environmental information
All unnecessary packaging material has been omitted. We have done our utmost to make the
packaging easily separable into three mono materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packaging
materials, exhausted batteries and old equipment.
RADIO RECEPTION
1. To select the desired station waveband, set the source
selector to AM/FM.
2. Tune to a radio station using the tuning knob.
– For FM, pull out the telescopic aerial.
Incline and turn the aerial. Reduce its length if the signal
is too strong (very close to a transmitter).
– For AM the set is provided with a built-in aerial so the
telescopic aerial is not needed. Direct the aerial by turning
the whole set.
3. Adjust the sound using the VOLUME, INCREDIBLE
SURROUND and BASS controls.
4. To switch off the radio, adjust the source selector to the
TAPE/OFF position (with the cassette keys released)

RADIO

9