Table of Contents
Advertisement
6.2 S-Motion sensor settings
Page 28
SF-Motion: non-contact optical sensors, Type 2059A..., 2059A...
The KiCenter software is needed to configure and
calibrate the sensor.
The software can be found on the included USB stick or at
www.kistler.com.
To connect the sensor to KiCenter, it must be connected
to the computer using either the USB connecting cable or
a LAN cable.
After pressing the "Browse Net" or "Browse All" button, the
sensor should appear in the KiCenter Device Tree.
A node and 3 pages are displayed in the "Device Tree":
ƒ Measurement Display
ƒ Sensor Configuration
ƒ CAN Bus
as well as the sensor designation and the serial number.
The following pages explain the options for the system
configuration, operation and data display.
2059A_002-956d-07.21
Advertisement
Table of Contents
Need help?
Do you have a question about the 2059A Series and is the answer not in the manual?
Questions and answers