NORMAL TROUBLE SHOOTING
Problem
The whole "
symbol is always on.
The unit enter the ice
making process, but
no water
flowing in
the unit, and the whole
"
" symbol is on.
Water
pump
working, but no water
flow out from the water
dividing pipe
The transparency of
the ice cube is not very
good
Ice
cube
shape
irregular
Ice cube is very thin
Ice cube is too thick
"
" indicator is on
Ice making cycle is
normal, but there is no
ice cube produced
Possible Cause
No water supply
Floating ball of the water level
"
detecting switch is blocked,
can't be raised up
Water flows out from the water
tank
Water flows out from the water
drain pipe of the water tank.
Water
supplying
breakdown, or water flows in
very slowly.
is
The little holes on the water
dividing pipe is blocked.
Water quality is bad
Water quality is not good or the
water tank is very dirty
is
The little holes on the water
dividing pipe is some blocked
Ambient temperature is too
high
Air circulation around the unit is
not goog
Ambient temperature is too low
The ice storage bin is full of the
ice cube.
The temperature of Ambient, or
water in water tank is too high
Refrigerant leakage
Cooling system tube is clogged
Check the main water supply pressure or
check the water supply hose is blocked or
not, adding the water pressure or cleaning
the hose necessary.
Clean the water tank and the water level
detecting switch。
Place the unit on the level position, not on
the slope。
Pull out the pipe and install back to the slot
of the water tank properly.
Check the main water supply pressure or
hose
check the water supply hose is blocked or
not, adding the water pressure or cleaning
the hose necessary.
Clean these little holes.
Change the water supply, or use the water
filter to soften or filter the water.
Clean the water tank, and change with new
water.。
Clean the water dividing pipe, make sure
all nine holes are unclogged
Move the unit to low temperature space, or
lengthen the time of each ice making cycle.
Make sure there is more than 20CM space
between the unit back & front and the
obstacle
Reduce the time of each ice making cycle.
Take out some ice cube
Move to the place with temperature lower
than 90Fahrenheit
to the low temperature water
Need the technical serviceman to maintain
Need the technical service person to
maintain
21
Solution
centigrade, and change
,
Need help?
Do you have a question about the HZB-90F and is the answer not in the manual?
Questions and answers