Coast HP7 - Flashlight Manual

For warranty and distributor information in your country, visit: www.COASTportland.com

BATTERY INSTALLATION

Turn the tailcap in a counterclockwise direction to remove the cap. Remove the battery cartridge. Place four AAA batteries into the cartridge in the direction indicated on the cartridge. Replace the cartridge in the light with the red end going in first. Replace the tail cap and turn it clockwise to tighten it until it is fully closed. Note – the HP7 in clampack packaging ships with batteries installed.

QUICK CYCLE SWITCH OPERATION

This flashlight is equipped with COAST's Quick Cycle Switch, featuring high and low beams.

To activate the high beam from the off position, press the on/off switch until it clicks once, then release. Press the on/off switch until it clicks a second time to turn off the light.

To activate the low mode, press the on/off switch until it clicks a third time, then release. Press the on/off switch until it clicks a fourth time to turn off the light.

The light can also be operated in "momentary" mode. Momentary mode is activated by partially depressing the on/off switch (less pressure than required for a full click). The momentary switch will cycle the light through the high and low beam modes.

Any time the light is turned off for more than five seconds, the high/ low cycle will reset and the high beam will be activated when the light is turned on again.

PURE BEAM FOCUSING OPTIC WITH SLIDE FOCUS

This flashlight is equipped with COAST's Pure Beam Focusing Optic with Slide Focus that allows the user to choose between a broad flood beam and a focused Bulls-Eye Spot beam for long distance illumination.

To adjust the beam into the Bulls-Eye Spot mode, slide the head of the light all the way forward.

To adjust the beam into the broad, flood light mode, slide the head of the flashlight back.

The beam can be locked into any position, from full flood beam to spot beam. To lock the beam in position, turn the head of the light to the left.

MAINTENANCE

Wipe the external body with a damp cloth. Do not submerge.