Maintenance - Husqvarna DC 655 Operator's Manual

1. Pull out the Longopac bag (A) and attach a cable tie
(B) to close the new Longopac bag.
B
2. Shake down the dust in the used Longopac bag.
3. Attach a cable tie 10 cm below the first cable tie to
close the used Longopac bag. Cut off the Longopac
bag between the cable ties.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
2061 - 002 - 19.04.2023
A
Read and understand the
4. If the remaining part of the Longopac bag cassette
is too small to prepare a new Longopac bag, install
a new Longopac bag cassette. Refer to
new Longopac dust bag on page 13 .
5. Obey local regulations for disposal of the full
Longopac bag.
To drain the water from the pressure
tank
Water in the pressurized air collects in the pressure
tank. It is necessary to drain the water from the pressure
tank daily.
1. Stop the product. Refer to
page 11 .
2. Put a container below the water extraction hose (A)
to collect the water.
3. Open the water valve (B).
4. Close the water valve when all the water is drained.

Maintenance

X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
To install a
To stop the product on
A
B
15