Advertisement
1
4
Step 1: Drill 2 holes, with a 3mm drill bit to the luminaire's mounting part.
Step 2: Install the terminal board and fasten it with the two included screws (use 3*4 screws, small one).
Step 3: Pass the cables through the hanging accessory and install it on the ceiling with the included mounting parts.
Step 4: Screw the luminaire mounting part with the two included mounting screws and pass through the power cable.
Step 5: Connect the mains cables to terminal blocks: L for live wire and N for neutral. Power supply cables cross section
should be 0.8 - 3 mm . Tighten the cable tie around the cables.
Step 6: Slide the main body of the luminaire back to the mounting part.
1
4
Step 1: Drill 2 holes, with a 3mm drill bit to the luminaire's mounting part.
Step 2: Install the terminal board and fasten it with the two included screws
Step 3: Drill a hole on a black grommet and pass the mains cables through it. Connect the mains cables to
terminal blocks: L for live wire and N for neutral. Power supply cables cross section should be 0.8 - 3
2
mm . Tighten the cable tie around the cables.
Step 4: Fasten the mounting part with the supplied mounting accessories.
Step 5: Slide the main body of the luminaire back to the mounting part.
The light source contained in this luminaire shall only be replaced by the manufacturer, or his agent, or
a similar qualified person.
NOTE! The light source is non-user replaceable.
Honeywell Life Safety AS, Po. Box 3514, N-3007 Drammen, Norway
Hanging Mounting
2
5
2
Wall Mounting
2
5
3
6
C1
C2
N
L
3
(use 3*4 screws, small one).
http://www.hls-nordic.com
GB
C1
C2
N
L
Advertisement
