Remove The Heat Sink - Lenovo ThinkSmart View Plus Hardware Maintenance Manual

Remove the heat sink

Prerequisite
Turn off ThinkSmart View Plus and wait several minutes until it is cool.
For access, do the following:
1. Remove the cable tie. See "Remove the cable tie" on page 14.
2. Remove the camera module. See "Remove the camera module" on page 15.
3. Remove the Soundbar. See "Remove the Soundbar" on page 15.
4. Remove the Stylus Pen. See "Remove the Stylus Pen" on page 16.
5. Disconnect the power cord from electrical outlet and disconnect all the cables from the device.
6. Place a clean soft cloth, and then lay down the device with the back cover facing up.
7. Remove the stand with base. See "Remove the stand with base" on page 16.
Removal steps
Attention: Use the screws provided by Lenovo to avoid any unpredictable damage to your device.
Step Screw (quantity)
1
M3 × 4.5 mm, flat-head (4)
18
ThinkSmart View Plus Hardware Maintenance Manual
Torque
Color
Silver 0.18±0.05 Nm
(1.8±0.5 kgf-cm)