Tool Kits - Siemens LDS 6 Operating Instructions Manual

Appendix
A.2 Tool kits
A.2

Tool kits

Siemens provide toolkits to be used for installation, maintenance and service of the LDS 6
laser gas analyzer. These toolkit are described in this appendix.
Flange Alignment Kit
The Flange Alignment Kit (shown below) is intended for use when installing the two opposite
process flanges on the measurement volume. It consists of a light source, two alignment
flanges, an aiming tool, a battery for the light source and a battery charger. The light source
is a halogen lamp with a wide beam angle and can consequently be mounted on non aligned
process flanges (which will be the case when the first flange is aligned).
Figure A-2
1. Light source
2. Alignment flanges
3. Aiming tool
4. Battery
5. Charger
42
2
4
The Flange Alignment Kit
Sensor CD 6C Operating Instructions
Operating Instructions, 12/2007, A5E00912721-02
5
3
1