Installation - LEAB MELFBOX User Manual

6 Installation

6 Installation
Preparation
Before connecting the unit, proceed as follows:
CAUTION! Install a suitable fuse in the vehicle (up to 16 A).
1. Route a connection cable (H07RN-F, 3 x 2.5) in the vehicle.
2. Attach the connection cable to the vehicle installation.
3. Optional: Route a cable (H05RN-F, 2 x 0.5) for the immobiliser in the vehicle
and connect it to the specific vehicle installation (control module or similar).
ð The unit is now ready to be connected.
Connecting the Supply Unit
Optional: Connecting the Immobiliser
8 LEAB Automotive GmbH
To connect the device, proceed as follows:
4. Pierce the housing seal at the intended location with a
pointed tool.
5. Feed the connection cable (H07RN-F, 3 x 2.5) through the
hole.
6. Connect the wires of the connection cable to the corres-
ponding screw terminals.
ð The device is connected.
TIP
The MelfBox has a potential-free switching contact (normally open
contact) to create an immobiliser.
The design of the immobiliser depends on the vehicle. Inquire from
your vehicle manufacturer.
LEAB Automotive GmbH
Thorshammer 6 24866 Busdorf