Table of Contents
Advertisement
Available languages
Available languages
When disconnecting the unit from the power supply, do not pull on the power cord, pull on
the power plug.
Use the power cable provided with your Blueair air purifier to plug directly and firmly into an
appropriate, electrical outlet.
Do not use an extension cord or a power strip. Refer to the rating label on your appliance.
Do not alter the power plug in any way. If the plug does not fit into the outlet, contact
qualified personnel to install the proper outlet.
Do not use the included power cord for anything else but the appliance.
Do not allow objects to enter or block the air inlets and air outlets as this can cause electric
shock or damage the appliance.
Do not place any objects on top of or directly against the appliance.
Do not sit on, stand, climb onto or hang from the appliance.
Keep the appliance, including the power cable, at a safe distance from heated surfaces and
open fire.
Keep the appliance and power plug away from water and other liquids.
Keep the appliance and power plug away from chemicals such as pesticides and deodorants.
Place the air purifier on the floor or a stable surface to prevent tipping.
Do not use the appliance outdoors or in wet environments such as bathrooms, laundry
rooms or pool areas.
Always turn off and disconnect the appliance from the power supply before moving the unit,
changing filters, cleaning or carrying out maintenance procedures.
Never clean with gasoline, chemical solvents, or corrosive materials as these agents may
damage the air purifier.
- Quick Links:
- Getting Started
- Maintenance Information
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Blue Pure 511 and is the answer not in the manual?
Questions and answers
Wont turn on
The Blueair Blue Pure 511 may not turn on due to the following reasons:
1. Power Supply Issues – Ensure that the power cable and plug are not damaged and are properly connected to a working power outlet.
2. Safety Precautions – The device should only be used indoors and must be disconnected from power before maintenance. If any safety feature prevents operation, check for proper setup.
3. Filter Installation – Ensure the filter and pre-filter are correctly installed and locked in place. The device may not function if the filter is not properly secured.
4. Maintenance Reset – If the filter indicator is active, reset it by holding the button for 15 seconds until the light turns white.
5. Electrical Damage – If the power cable is damaged, it must be replaced by the manufacturer or a qualified service agent.
If the issue persists, contact Blueair support or a qualified technician.
This answer is automatically generated
I cleaned the 511 as directed and changed the filters. The three top (circle) bars still light up red. Now that changes were made as directed and cleaned too why aren’t the three bars on top the color blue instead of red?
The three top bars on the Blueair Blue Pure 511 remain red after cleaning and changing the filters because the filter indicator has not been reset. After replacing the main filter, you must press the button for 15 seconds until the light turns white to reset the filter indicator.
This answer is automatically generated