EZVIZ DP1 - Wire-free Smart Door Viewer Manual

Also See for DP1:

Table of Contents

Attention

Do not expose the camera to the harsh environment like high temperature, humid, salt mist, or rain, otherwise, the device may be damaged.
Do not press the sensor or lens of the camera, otherwise, the device may be damaged.
Do not pull the wire of the camera hardly, and protect yourself from being cut by the wire. Damage to the wire due to inappropriate operation is not included in the warranty.
Use the exclusively power adapter to charge the panel, otherwise, the system may be damaged.

Overview - Panel

Overview - Camera
information Do not block the sensors.

Overview - Mounting Base

If you used to install the peephole, remove it and install the device in the same place. If not, please drill a hole of diameter about 16.5 to 30mm and about 145cm distance from the ground to have a good viewing effect.

Hold the power button for 3 to 5 seconds to power up the panel.

Tap to set detailed parameters as you desired such as Display, Monitoring, Date, and etc.

Create an user account.
- Connect your mobile phone to Wi-Fi.
- Download and install the EZVIZ app by searching "EZVIZ" in App Store and Google Play. TM
- Launch the app and register an EZVIZ user account following the start-up wizard.
Add a camera to EZVIZ.
- Log in the EZVIZ app.
- On the Home screen, tap "+" on the upper-right corner to go to the scan QR code page.
- Scan the QR code.
  
  Tap Firmware Info to view the QR code.