Accessories Chart - DeWalt DWE46253-CA Instruction Manual

5" (125 mm) and 6" (150 mm) grinding Wheels
Type 27 guard*
unthreaded backing flange
Type 27
depressed center wheel
threaded locking flange
5" (125 mm) and 6" (150 mm) Cutting Wheels
Type 1/41 guard*
unthreaded backing flange
Type 27/42 depressed
center wheel, cutting only
threaded locking flange

Type 1/41 guards are intended for use with Type 1/41 cutting wheels and Type 27 wheels marked for cutting only.
Grinding with wheels other than Type 27 and Type 29 require different accessory guards. Always use the smallest proper
guard possible that does not contact the accessory.
* nOTE: A Type 27 or traditional Type 1/41 guard is available at extra cost from your local dealer or authorized service center.

ACCESSORIES CHART

Type 27 guard*
Type 27 hubbed wheel
5" (125 mm) and 6" (150 mm) sanding Flap Discs
Type 27 guard*
unthreaded backing flange
non-hubbed sanding flap disc
threaded locking flange
Type 1/41 guard*
unthreaded backing flange
Type 1/41 abrasive cutting
wheel
threaded locking flange
Wire Wheels
Type 27 guard*
3 - 5" * (76.2 - 127 mm)
wire cup brush
Type 27 guard*
hubbed sanding flap disc
Type 1/41 guard*
unthreaded backing flange
diamond cutting wheel
threaded locking flange
English
Type 27 guard*
4"-6" (100-150 mm) wire
wheel
sanding Discs
rubber backing pad
sanding disc
sanding clamp nut
surface Finishing Pads
loop backing pad
surface finishing pad
13