Troubleshooting - caddytrek R3 User Manual

V. T S
ROUBLE HOOTING
Powering On:
If no response after two minutes of powering on, reboot the R3.
If after 45 seconds, if you don't hear a beep and a green blinking
light, reboot the R3.
To reboot the R3, turn off the unit and then turn back on.
Must have blinking green light to use camera for follow mode.
If you see red light on LED then reboot the R3.
Pairing:
If you see 4 green lights on handset, then pairing was
UNSUCCESSFUL. Re-do the process.
Bright Sun
Like any other camera, facing directly into the sun may cause sun
glare. Shadow the camera with your body.
When covering camera to activate follow mode, if after FIRST
attempt fails, wait TWO seconds then try again.
We suggest blacking out the camera (without touching the lens) by
cupping the camera using your hand.
When using follow mode and walking directly into the sun, to
prevent sun glare, it is suggested to use "zigzag" method.
See video - refer to page 10, "Precautions."
Motor Noise:
If continuous large motor noise under RC mode (pause on slope
etc.), please change to SB mode to eliminate motor noise.
Pg. 12