Advertisement
9.3.6.
Rotate calibrated vernier dial to raise / lower the spindle stop in order to make fine depth adjustment (CCW to decrease, CW to increase).
9.3.7.
Release the clamp and verify correct depth setting.
fig.11
fig.14
10. MAINTENANCE
WARNING! Always ensure that the battery is removed before commencing any maintenance.
‰
10.1.
Check the safety guard is situated correctly and not broken.
10.2.
To prolong the useful life of the router always clean it thoroughly after use and protect bits with a rust preventative.
DO NOT clean with any solvents as they may attack the material. Clean the router with a dry cloth and remove sawdust from ventilation
8
slots.
© Jack Sealey Limited
fig.12
Features that enable depth of cut to be
set (see section 9.3).
Original Language Version
fig.13
CP20VTR Issue 1 15/02/2023
Advertisement
