RoamAlert AR3KY01-030 Installation Manual

RoamAlert AR3KY01-030 Installation Manual

Access keypad

Advertisement

Access Keypad
Access Keypad
Installation Guide
Installation Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AR3KY01-030 and is the answer not in the manual?

Questions and answers

Summary of Contents for RoamAlert AR3KY01-030

  • Page 1 Access Keypad Access Keypad Installation Guide Installation Guide...
  • Page 2 Warranty Stanley Healthcare Solutions' products are warranted against defects in materials and workmanship and shall perform in accordance with published specifications for 1 year. Stanley Healthcare Solutions' warranty is limited solely to the repair or replacement of the defective part or product. Stanley Healthcare Solutions reserves the right to change product specifications without notice.
  • Page 3 Up to 1000 unique PIN (Personal Identification Number) codes can be stored in the door controller and managed at the RoamAlert server PC. In this mode, the Access Keypad software tracks each code in the Activity Log. Use this mode when the facility requires a record of which staff member bypassed the exit at a specific date and time.
  • Page 4 Specifications Input Rating 12 VDC @ 200 mA Operating/Storage Temp 32° F to 120° F (0° C to 49° C) Relative Humidity 0-85% RH @ 70° F (21° C) non-condensing Dimensions 4.5” L x 2.75” W x 2.5” H (11.5 x 7.0 x 6.5 cm) Mounting B11R Carlon Retrofit box (supplied) Installation Tips...
  • Page 5 placement (not crooked) of all exposed components is the hallmark of a professional installation. Run the supplied keypad cable from the KEYPAD jack on the controller front panel into the electrical box and connect to the keypad jack. Mount the keypad into the electrical box or into the retrofit bracket with the supplied screws.
  • Page 6 Press Enter a new passcode (3 to 6 digits). Press Note the new Master Pass Code and store in a safe place. To restore a factory default code, follow these steps: Make sure the keypad has power. Enter the Master Pass Code. Press Enter the slot number (1 or 3 for Bypass, 2 or 4 for Reset).
  • Page 7 Bottom Two = Mode 2 Figure 1: Keypad Jumper Locations Connecting a Third-Party Keypad to a Controller Third-party keypads can be connected to a Halo or RoamAlert R3 controller using a 6P6C modular plug according to the following pin-outs at the controller keypad jack,...
  • Page 8 Stanley Security Solutions Senior Technologies Division 1550 N. 20th Circle Lincoln, NE 68503 Telephone: USA: 800-824-2996 Canada: 866-559-6275 Int’l: +1 (613) 592-6997 Web site: www.stanleyhealthcare.com © 2009 XMARK Corporation. All Rights Reserved. August 2009. 981-000018-000 Rev 03.

Table of Contents

Save PDF