TECH EU-R-8PZ Plus User Manual

TECH company ensures to the Buyer proper operation of the device for the period of 24 months from the date of sale. The Guarantor
undertakes to repair the device free of charge if the defects occurred through the manufacturer's fault. The device should be delivered to its
manufacturer. Principles of conduct in the case of a complaint are determined by the Act on specifi c terms and conditions of consumer sale and
amendments of the Civil Code (Journal of Laws of 5 September 2002).
CAUTION! THE TEMPERATURE SENSOR CANNOT BE IMMERSED IN ANY LIQUID (OIL ETC). THIS MAY RESULT IN DAMAGING THE CONTROLLER
AND LOSS OF WARRANTY! THE ACCEPTABLE RELATIVE HUMIDITY OF THE CONTROLLER'S ENVIRONMENT IS 5÷85% REL.H. WITHOUT THE STEAM
CONDENSATION EFFECT.
THE DEVICE IS NOT INTENDED TO BE OPERATED BY CHILDREN.
Activities related to setting and regulation of the controller parameters described in the Instruction Manual and parts wearing out during normal
operation, such as fuses, are not covered by warranty repairs. The warranty does not cover damages arising as a result of improper operation or
through the user's fault, mechanical damage or damage created as a result of fi re, fl ood, atmospheric discharges, overvoltage or short-circuit. The
interference of an unauthorized service, wilful repairs, modifi cations and construction changes cause the loss of Warranty. TECH controllers have
protective seals. Removing a seal results in the loss of Warranty.
The costs of unjustifi able service call to a defect will be borne exclusively by the buyer. The unjustifi able service call is defi ned as a call to remove
damages not resulting from the Guarantor's fault as well as a call considered unjustifi able by the service after diagnosing the device (e.g. damage
of the equipment through the fault of the client or not subject to Warranty), or if the device defect occurred for reasons lying beyond the device.
In order to execute the rights arising from this Warranty, the user is obliged, at his own cost and risk, deliver the device to the Guarantor along with
a correctly fi lled-in warranty card (containing in particular the sale date, the seller's signature and
a description of the defect) and sales proof (receipt, VAT invoice, etc.). The Warranty Card is the only basis for repair free of charge. The complaint
repair time is 14 days.
When the Warranty Card is lost or damaged, the manufacturer does not issue a duplicate.
.....................................
seller's stamp
SAFETY
Before using the device for the first time the user should read the
following regulations carefully. Not obeying the rules included in this
manual may lead to personal injuries or controller damage. The user's
manual should be stored in a safe place for further reference. In order to
avoid accidents and errors it should be ensured that every person using
the device has familiarized themselves with the principle of operation as
well as security functions of the controller. If the device is to be sold or
put in a diff erent place, make sure that the user's manual is there with
the device so that any potential user has access to essential information
about the device.
The manufacturer does not accept responsibility for any injuries or
damage resulting from negligence; therefore, users are obliged to take
the necessary safety measures listed in this manual to protect their lives
and property.
WARNING
• The device should be installed by a qualified electrician.
• The regulator is not intended to be used by children.
• Any use other than specified by the manufacturer is forbidden.
• High voltage! Make sure the regulator is disconnected from the
mains before performing any activities involving the power supply
(plugging cables, installing the device etc.).
• It is recommended to periodically check the condition of the
device.
EU DECLARATION OF CONFORMITY
Hereby, we declare under our sole responsibility that EU-R-8PZ Plus
manufactured by TECH STEROWNIKI, head-quartered in Wieprz Biała
Droga 31, 34-122 Wieprz, is compliant with Directive 2014/53/EU of
the European parliament and of the Council of 16 April 2014 on the
harmonisation of the laws of the Member States relating to the making
available on the market of radio equipment, Directive 2009/125/EC
establishing a framework for the setting of ecodesign requirements for
energy-related products as well as the regulation by the MINISTRY OF
ENTREPRENEURSHIP AND TECHNOLOGY of 24 June 2019 amending
the regulation concerning the essential requirements as regards the
restriction of the use of certain hazardous substances in electrical
and electronic equipment,
(EU) 2017/2102 of the European Parliament and of the Council of 15
November 2017 amending Directive 2011/65/EU on the restriction of
the use of certain hazardous substances in electrical and electronic
equipment (OJ L 305, 21.11.2017, p. 8).
For compliance assessment, harmonized standards were used:
PN-EN IEC 60730-2-9 :2019-06 art. 3.1a Safety of use
PN-EN 62479:2011 art. 3.1 a Safety of use
ETSI EN 301 489-1 V2.2.3 (2019-11) art.3.1b Electromagnetic
compatibility
ETSI EN 301 489-3 V2.1.1:2019-03
compatibility
ETSI EN 300 220-2 V3.2.1 (2018-06) art.3.2 Effective and coherent use
of radio spectrum
ETSI EN 300 220-1 V3.1.1 (2017-02) art.3.2 Effective and coherent use
of radio spectrum
EN IEC 63000:2018 RoHS.
Wieprz, 22.11.2022
WARRANTY CARD
implementing provisions of
art.3.1 b Electromagnetic
We are committed to protecting the environment. Manufacturing
electronic devices imposes an obligation of providing for environmentally
safe disposal of used electronic components and devices. Hence, we have
been entered into a register kept by the Inspection For Environmental
Protection. The crossed-out bin symbol on a product means that the
product may not be disposed of to household waste containers.
Recycling of wastes helps to protect the environment. The user is obliged
to transfer their used equipment to a collection point where all electric
and electronic components.
Power supply
Max. power consumption
Temperature adjustment range
Measurement error
Operation frequency
Humidity measurement range
Directive
The pictures and diagrams are for illustration purposes only.
The manufacturer reserves the right to introduce some hanges.
......................................
date of sale
TECHNICAL DATA
230V ± 10% / 50Hz
0,1W
50C ÷ 350C
± 0,50C
868MHz
10-95%RH