Weber Legi-Air 4050E Installation Manual page 94

Chapter 9 Troubleshooting
WAIT PROXIMITY 200
The number on the right is a 3-digit countdown that shows the remaining time (s. page
71), before the error E14 (s. page 92) will be generated if the sensor does not detect the
product within the configured timeout. At timeout-setting 255 = endless, the countdown
display is omitted.
READING BARCODE 050
During verifying the barcode the number on the right shows a 3-digit countdown,
according to the configured barcode reading.
PLATE RETRACTION
Assumed that the optional swing Tamp applicator and corner application have been
enabled, the message is temporarily displayed after having applied the label on the front
side, while the plate is wiping the label on the corner. The number on the right shows a 3-
digit countdown, according to the configured duration.
WAITING HOME 150
The number on the right shows a 3-digit countdown, according to the configured duration
(s. page 68), within the Tamp should been received to home position once the label has
been blown onto the product. At timeout-setting 255 = endless, the countdown display is
omitted.
Once the plate has returned back in home position, the following message is displayed:
CYCLE COMPLETE
The number on the right is a 3-digit countdown that shows the SYNC PULSE duration (ref.
page 75). This phase is normally very short, so this last message is barely noticeable,
being immediately overwritten by the first message of the next cycle.
MAINTENANCE!
The maintenance has to be arranged. The Hotline (s. page 8) is pleased to wait for your
order for a Service-Technician.
DOOR OPENING
This message is displayed when the shutter (option) of the protective cabinet is opened
for Tamp movement.
Version 27.01.15
050
005
Page 94 of 97
22800998 BTA LA 4050E
GB