Sealey SPL01 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instructions gloves
1. SAFETY
WARNING! The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations
‰
that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator. It is the operator's responsibility to secure the load. Check with vehicle manufacturer's Manual
before installing.
WARNING! Before use, ensure that there is nothing attached to the front forks or the fairing of the motorcycle that will foul the unit.
‰
Proper use and installation of this product is critical to safety. Improper use may result in personal or property damage which is not
9
covered by the warranty.
Proper care and maintenance of the unit is critical to safety.
9
Keep the unit clean for the best and safest performance.
9
Maintain correct balance and footing whilst positioning the motorcycle in the unit.
9
Ensure that the floor is not slippery and wear non-slip shoes.
9
Ensure that the motorcycle is adequately secured to the unit if to be used for transportation purposes.
9
Keep children and unauthorised persons away from work area.
9
Inspect unit before each use. Check fasteners for tightness, replace any worn or damaged parts.
9
Before removing a motorcycle from the unit, ensure that there are no obstructions or persons in the path of the motorcycle.
9
DO NOT attempt to use a unit that is damaged in any way.
8
DO NOT modify the unit in any way.
8
DO NOT use the unit for a purpose it is not designed to perform.
8
DO NOT operate the unit if it is damaged.
8
DO NOT use the unit when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT allow untrained persons to use the unit.
8
2. INTRODUCTION
Securely holds your motocross bike on to a trailer or van, with the Fast Lock system, no ratchet straps or wheel chock required.
Provided with mounting plates and quick release latches, allowing for fast installation and removal of the clamp, freeing your vehicle
for other uses. Each mounting plate has a D-ring creating additional anchor points to the trailer floor.
3. SPECIFICATION
Model No: ............................................................ SPL01
Foot peg width from tip to tip:18"-20" (455mm-510mm), foot peg height: 15"-17.5" (380mm-445mm)).
The SPL01 is designed to fit 125 - 500cc bikes with similar geometry (Foot peg width from tip to tip: 18"-20"(455mm-510mm), foot
peg height: 12.5"-14.75" (320mm-375mm)). NOTE: Often trail bikes WITHOUT a folding shift lever will not fit.
© Jack Sealey Limited
FAST LOCK TIE DOWN SYSTEM
MODEL NO:
Wear safety Wear protective
footwear clothing
Original Language Version
SPL01
SPL01 Issue 1 12/12/22