Advertisement
Quick Links
NEVER LEAVE CHILDREN ALONE OR UNAT-
TENDED IN THE AREA WHERE A CONVECTION MICRO-
WAVE DRAWER IS IN USE. NEVER LEAVE THE DRAWER
OPEN WHEN THE OVEN IS UNATTENDED.
STEPPING, LEANING OR SITTING ON THE
DRAWER MAY RESULT IN SERIOUS INJURIES AND CAN
ALSO CAUSE DAMAGE TO THE CONVECTION MICROWAVE
DRAWER.
Advertisement
Related Manuals for Sharp SMD2499FSC
Summary of Contents for Sharp SMD2499FSC
- Page 1 NEVER LEAVE CHILDREN ALONE OR UNAT- TENDED IN THE AREA WHERE A CONVECTION MICRO- WAVE DRAWER IS IN USE. NEVER LEAVE THE DRAWER OPEN WHEN THE OVEN IS UNATTENDED. STEPPING, LEANING OR SITTING ON THE DRAWER MAY RESULT IN SERIOUS INJURIES AND CAN ALSO CAUSE DAMAGE TO THE CONVECTION MICROWAVE DRAWER.
-
Page 2: Clearances And Dimensions
J l diameter hole /2" and deburred of ail sharp edges. •@Qej;jü/j• Always allow sufficient power cord length to the electrical outlet to prevent tension. Always check electrical codes for requirements. - Page 3 Figure 3 represents a typical standard cabinet. If installed in custom cabinets with extended countertops, take into account visibility and access to controls. See Figure 4. A. 25" (635 mm) B. 1/2'' (12.7 mm) minimum C . 19 5/s" (498.48 mm) D.
- Page 4 24" CONVECTION MICROWAVE DRAWER FLUSH MOUNT AND MEASUREMENTS Prepare cabinet opening as shown in Figures 5, 6, 7 A. Suggested electrical outlet location B. 5" (127 mm) C. 4" (101.60 mm) D. 23 7/s" (606.43 mm) opening E. 19 3/s" (492.12 mm) F.
-
Page 5: Electrical Outlet
ELECTRICAL OUTLET DRAWER INSTALLATION The electrical requirements are a 120 volt 60 Hz, AC only, 20 amp. 1. Place the Convection Microwave Drawer adjacent to the or more protected electrical supply. lt is recommended that a wall or cabinet opening. Plug the power supply cord into the electrical outlet. - Page 6 •...