Table of Contents
Advertisement
prevent damage from other items in the dishwasher.
To remove the grease filter, push in the button on the handle and then
pull down on the filter at the front as shown in figure 2. When you
have released it at the front, then you can pull the filter out completely.
After rinsing and drying, reassemble the grease filter to the hood by
reversing the removal process.
Please note:
Cleaning the grease filter in the dishwasher may lead to
discolouration. This is normal and does not constitute a fault with the
appliance.
Changing the charcoal filter (re-circulating only)
To ensure best performance of your extractor, you should replace the
charcoal filter every four to six months, depending on use.
To attach a new charcoal filter, first remove the grease filters as
described above.
Offer up the charcoal filter so that the magnetic pins are facing upwards,
one to the rear and one to either side. The filter will be held in place by
magnetic force. Finally replace the grease filters.
7
- Quick Links:
- Care and Maintenance
- Installation
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ECP Series and is the answer not in the manual?
Questions and answers
I have recently installed a ECP92SS but, while the **** maks pleanty of noise, it doesan't actjally seem to extract to any significant extent.
The CDA ECP92SS may not be extracting air effectively despite making noise due to several possible reasons:
1. Blocked or Saturated Charcoal Filter – If the extractor is in recirculating mode, the charcoal filter may need replacing.
2. Incorrect Ducting – If the ducting is too long, has too many bends, or is of insufficient diameter (less than 125mm), it can reduce airflow and increase noise.
3. Obstructed Ventilation – Blockages in the ducting or external vent can restrict airflow.
4. Improper Installation – If the extractor is installed too high above the hob or with incorrect ducting, efficiency may be reduced.
5. Fan or Motor Issues – A faulty motor or fan may cause noise without effectively moving air.
Checking and addressing these factors can improve extraction performance.
This answer is automatically generated