ujk technology 109294 Quick Start Manual

Contains four adjustable hinge apertures.

Can be used for hinges between 50mm(2") - 127mm(5") x 6.5mm - 35mm.

Comes in two parts for easy storage.

Based on a 2 metre door, the hinge positions are 6" from top; 20" from top; middle; and 9" from

base.
Overall Length of 1815mm (Approx 6')

Has an end datum stop to control the 3mm gap between the top

of the door and the frame.
Other Equipment required:-
12mm diameter straight cutter (666262).

16mm diameter guide bush.

At least two bradawls (109377) to secure

jig to door/frame.
Engraved marking allows
easy hinge measurement
and setting.
A datum end stop
provides accurate
hinge positioning on
the door and frame.
Adjustable Hinge Jig
A sliding plate allows hinge
length adjustment.
Connecting Plate
Code 109294
Original Instructions
The depth datum
butts up against the
door or frame to
control the depth of
the hinge.
The depth of the
hinge can easily be
set. The hinge sits
in place within the jig
and the depth datum
is adjusted to suit.
Hinge sizes possible
6.5 - 35mm