Camp Chef Expedition 3X TB-90LWC09 - Stove Manual

Table of Contents

Contents

1 Features
2 IF YOU SMELL GAS
3 FOR OUTDOOR USE ONLY
4 FUEL TYPE
5 FUEL CYLINDER
6 COMBUSTIBLE MATERIALS
7 FOR YOUR SAFETY
8 TB90LWC 09 PARTS LIST
9 How to use
10 REGULATOR
11 TROUBLESHOOTING
- 11.1 PROBLEM WITH FLAME?
12 Documents / Resources
- 12.1 Download manual

Features

THIS INSTRUCTION MANUAL CONTAINS IMPORTANT INFORMATION NECESSARY FOR THE PROPER ASSEMBLY AND SAFE USE OF THIS PRODUCT.KEEP FOR FUTURE REFERENCE

Powerful 3-burner Universal Output System
90,000 Total BTU/hr of Output
78.7 cm (31 in.) Cooking Height
Detachable Legs
3-Sided Windscreen

Read Thoroughly
Before Use
DO NOT DISCARD THESE SAFETY INSTRUCTIONS

IF YOU SMELL GAS

Disconnect gas to the appliance.
Extinguish any open flame.
If odor continues, immediately leave the premises and call your gas supplier or local fire department.

FOR OUTDOOR USE ONLY

If stored indoors, detach hoses and leave fuel cylinder outdoors, with valve closed and plugged.

FUEL TYPE

This unit is designed for use with propane only.
No other fuel is approved for use with this unit.

FUEL CYLINDER

Always store fuel bottles in a safe outdoor area with valve closed and plugged. Follow the manufacturer's recommendation for proper use and storage of propane cylinders. Do Not Place Propane Cylinders Directly Under Any Part of the Burners.

Place the tank so as to minimize the possibility of someone tripping over the connection hoses while the cooker is set up. Never Lean Over or Stand too Near the Cooker, or Allow Children or Pets Near the Cooker During Use.

COMBUSTIBLE MATERIALS

During operation of cooker, insure proper clearance from any combustible materials, in relation to the top, sides and back of cooking appliance. For outside use only. Do not use near flammable walls or under eaves or overhangs of homes or garages. Never leave unattended while hot or in use. Allow cooker to cool before take down and storage. The propane tank must always be stored outdoors in a well ventilated space. Never Stand or Lean Over Cooker Burner While Lighting.

FOR YOUR SAFETY

Follow all safety, set-up, lighting and cooking instructions. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

TB90LWC 09 PARTS LIST

ITEMS NOT SHOWN
CARRY BAG (1) 3-CB90
PARTS LIST

How to use

Screw out thumb screws until flush with inside of cooker leg. Apply extension to each leg. Hand tighten thumb screws. Stand cooker upright on solid level ground. To level: loosen thumb screw on leg extension and adjust leg height. Hand tighten thumb screw.
Use an adjustable or 3/4" wrench to connect flare fitting to stove fitting. Tighten securely with wrench. DO NOT OVER-TIGHTEN. Before attaching regulator to tank, ensure that all valves are in the OFF position.
Attach regulator to tank. Check all connections to ensure tightness. With all valves in the off position, apply a soapy water solution to all fittings, valves and connections. Turn gas on at the tank and check for leaks at all connections. Small bubbles will appear if connection leaks. Tighten as needed.
Fully open LP bottle valve. Turn valve to medium position. Allow gas to flow to burner. Immediately turn rotary ignitor. The ignitor should spark and light the burner. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat the lighting procedures.

REGULATOR

New Type 1 Connection: Right hand turn to connect securely to New Type 1 tank.

TROUBLESHOOTING

PROBLEM WITH FLAME?

(Flame should burn blue with a hint of yellow.)
Yellow Flame: Adjust air shutter open until burner shows blue flame.
Still Yellow: Shut off valve(s) at stove and fuel tank. Through air shutter opening, clean venturi (burner neck) of obstructions such as cobwebs, dirt or bugs.

Open Tank Valve Slowly
Small Flame: Flame will not adjust any larger... (Safety Feature: New Low Pressure Regulator will detect a sudden use of gas and automatically go into a "low flow" mode and needs to be reset) Turn off all valves at stove and at tank. Assure all fittings are tight and in good repair. Test for leaks. Repeat steps 2, 3 and 4.
Open Tank Valve Slowly