Muse M-350 BT/BTW/BTR/BTM - Wireless Portable Bluetooth Speaker Manual

LOCATION OF CONTROLS

1. Bluetooth (Blue LED) / AUX IN (Red LED) Indicator
2. MIC Built-in Microphone
3. Charging Indicator (Red LED)
4. PLAY / PAUSE
   Receive call / Transfer call / End call
   PAIR Bluetooth pairing / Disconnect Bluetooth connection
5. Volume Up / Next
6. Volume Down / Previous
7. POWER ON/OFF Switch
8. AUX IN jack
9. Charging Port

POWER SUPPLY

The unit is powered by a built-in, lithium-polymer rechargeable battery. Charge the built-in battery for at least four hours before using the device for the first time.
To charge the internal battery, connect the smaller end of the supplied USB cable to the Micro USB jack and the other end to a powered USB jack on your computer or an AC power supply (not included).
The charging indicator will light solid red during charging, and will off when fully charged.

Warnings:

• 
  The built-in battery in this device may present a risk of fire or chemical burn if mistreated. Do not disassemble, heat above 100°C (212°F), or incinerate.
• To get the longest service life of the built-in battery, charge at indoor-temperature.
• Attention should be drawn to the environmental aspects of battery disposal.
• Do not throw battery in fire!
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
• When the battery is low, the unit will sound a warning voice.
  The unit will switch to standby mode automatically when the battery is too low to work.

OPERATION

The Bluetooth^® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by New One S.A.S is under license. Other trademarks and trade names are those of their respective owners.

Hereby, NEW ONE S.A.S, declares that this MUSE M-350 BT/ M-350 BTW/M-350 BTR/M-350 BTM is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. The declaration of conformity may be consulted at http://www.muse-europe.com/conformity/ M-350BT.pdf

Turning the speaker on/off

1. Turn ON: Slide the ON/OFF switch to ON position. The blue LED light will blink with an indication voice.
2. Turn OFF: Slide the ON/OFF switch to OFF position. The LED light will turn off.

Pairing a Bluetooth Device

1. Turn off the Bluetooth functionality of other devices that were paired with your unit.
2. Slide the ON/OFF button to ON position to turn on the unit, the Bluetooth indicator will blink blue with an indication voice, then it will start rapidly to be in Pairing mode,
3. Turn on Bluetooth functionality on your Bluetooth device. Typically, Bluetooth controls are found on the device's tools or settings menu (see your user manual). Turn on Bluetooth connectivity and make your device "discoverable".
4. Clean out the paring list on your Bluetooth device.
5. Choose "add a new Bluetooth device" or "setup Bluetooth device" on your device. It will start to search. Once "M-350 BT" shows on your device, select it. If your device prompts you for a pass code, please enter 0000. If the pairing attempt fails or times out, please start pairing procedure again (see steps 2-5).
6. After your device and the "M-350 BT" have connected each other, a tone voice can be heard.

Using a Bluetooth Device

1. Slide the ON/OFF switch to ON position to turn on the unit. With a unit paired (see previous section), operate your Bluetooth device and its sound will be heard through the M-350 BT's speakers.
2. Press the button to pause playback. Press again to resume playback.
3. Press and hold the button to increase the volume, press and hold the button to decrease the volume. You can also adjust the volume on the device to which you are paired.
4. Press the button to skip to the next track. Press the button to skip to the previous track.
5. Press and hold button to disconnect from your current Bluetooth device.

Note: The Bluetooth indicator will blink slowly during playback.

Receiving/Dialing a Phone Call

This unit is equipped with a built-in microphone, which allows you to make or end calls of a connected mobile phone through this unit. Make sure your Bluetooth-enabled mobile phone is paired with the unit. When there is an incoming call to the connected mobile phone, you will hear an incoming call alert tone from the unit.

1. Press the button answer the incoming call.
2. Press the button again to end call.
3. Press the button twice to reject the incoming call.
4. To transfer the sound between the unit and the mobile phone, press and hold the button during a call.
5. To redial the last number retained in the memory of the mobile phone, press the button twice.

Notes:

• Re-dialing function is unavailable if there is no dial record feature in your mobile phone.
• This unit will not operate or may operate improperly with some Bluetooth mobile phones/audio players.
• If the conversation is not clear, try to move closer to the microphone.

IMPORTANT NOTICE

Automatic OFF mode
If no operation occurs in ON mode, the unit will automatically turn off after approx. 2 hours with a warning tone. To turn on the unit again, please follow the instructions mentioned in this instruction manual.

Using the Aux in Jack

1. Slide the ON/OFF switch to ON position to turn on the unit.
2. Insert one end of Aux In cable (not included) into the Line OUT or Headphone jack on your external audio unit and the other end into the AUX IN jack of the M-350 BT; the unit will automatically switch to Aux In mode. The Bluetooth indicator will light solid red, indicating that the unit is in Aux In mode.
3. Start playback of the external unit and the external audio unit's output sound will be heard through the M-350 BT's speakers.
4. Adjust the volume to desired level.
5. To stop playback, disconnect the Aux In cable from the Aux In jack; the unit will switch to Bluetooth mode automatically.

TROUBLESHOOTING GUIDE

Should this unit exhibit a problem, check the following before seeking service:

No Power

• Power is not on; Slide the ON/OFF switch to ON position to turn on the unit.
• Make sure the battery is recharged.

No Sound – General

• External device's volume is set to minimum; raise volume.
• The M-350 BT's volume is set to minimum; raise volume.
• The audio cable is plugged in. Unplug cable if not using Aux In function.

The Bluetooth device cannot pair or connect with the unit.

• You have not activated the Bluetooth function of your device. Refer to the user manual of your device to activate Bluetooth function.
• The unit is not in pairing mode. Turn off the Bluetooth functionality of other devices that were paired with your unit. Turn on the unit and re-enter the paring mode. If the unit is in Aux In mode, disconnect the Aux In cable from the Aux In jack to switch to Bluetooth mode automatically.

SPECIFICATIONS

GENERAL
Output Power: 2x3W
Dimensions: 170x 52 x 68mm

RECHARGEABLE BATTERY
Battery Type: 3.7V 1000mAh Lithium Polymer Battery
Charging voltage: DC 5V 500mA
Operating Time: A pprox. 6 hours at 50% volume after fully charged
Charging Time: Approx. 2 hours

BLUETOOTH
Bluetooth Version: V2.1+EDR
Working Distance: Up to 10 meters measured in open space
(wall and structures may affect range of device)

Specifications are subject to change without notice.

SAFETY INSTURCTIONS

To reduce the risk of electric shock, do not remove the cover (or back).

There are no user serviceable parts inside the unit. Refer all servicing to qualify personnel.

The lightening flash with arrowhead symbol within the triangle is a warning sign alerting the user of "dangerous voltage" inside the unit.

The exclamation point within the triangle is a warning sign alerting the user of important instructions accompanying the product.

• The ventilation should not be impeded by covering the ventilation openings with items such as newspapers, tablecloths, curtains, etc.
• No naked flame sources, such as lighted candles, should be placed on the apparatus.
• The use of apparatus in moderate climates.
• The apparatus should not be exposed to dripping or splashing.
• Ensure a minimum distance of 5cm around the apparatus for sufficient ventilation.
• Do not place objects filled with liquids, such as vases, on the apparatus.
• The Marking plate is located at the bottom of the device.
• Under the influence of electrical fast transient or/and electrostatic phenomenon, the product may malfunction and require user to power reset.

If at any time in the future you should need to dispose of this product please note that Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.(Waste Electrical and Electronic Equipment Directive)

NEW ONE S.A.S
10, Rue de la Mission, 25480 Ecole Valentin, France

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Muse M-350 BT/BTW/BTR/BTM - Wireless Portable Bluetooth Speaker Manual